Gorenje ECS8P2 405824 ユーザーズマニュアル
製品コード
405824
406342
millimeters from the lower surface of the worktop. The space
between the partition wall and the hob must be empty; no
objects should be placed into that gap.
between the partition wall and the hob must be empty; no
objects should be placed into that gap.
• On the furniture back wall there should be a cutout with width
of at least 175 mm along the entire width of the furniture
element.
element.
• Only type EVP4..,EVP2.., ovens fi tted with a cooling fan may
be installed underneath this cooking hob.
Installation procedure
• The worktop should be installed completely horizontally.
• The cutoff surfaces should be appropriately protected.
• Attach the fastening elements (4x - SVK6…600 mm; 6x
• The worktop should be installed completely horizontally.
• The cutoff surfaces should be appropriately protected.
• Attach the fastening elements (4x - SVK6…600 mm; 6x
- SVK7…750 mm; 6x - SVK8…850 mm) with the supplied
screws (4x - SVK6…600 mm; 6x - SVK7…750 mm; 6x
- SVK8…850 mm) to the left and right wall of the cooking hob
and the worktop cutoff.
screws (4x - SVK6…600 mm; 6x - SVK7…750 mm; 6x
- SVK8…850 mm) to the left and right wall of the cooking hob
and the worktop cutoff.
• Connect the cooking hob to the power mains (see instructions
for connecting a cooking hob on a power network).
• Insert the cooking hob into he cutoff and press it heavily from
above against the worktop.
• For screwing down the fi xing clip it is not allowed to use
screws longer than 6,5 mm.
• The appliance may only be connected by an authorized skilled technician.
• Electric system protection should comply with all relevant regulations.
• The connection clips can be accessed when the connection clip covers are opened / removed.
• Before connecting the appliance, make sure the voltage indicated on the rating plate is consistent
• Electric system protection should comply with all relevant regulations.
• The connection clips can be accessed when the connection clip covers are opened / removed.
• Before connecting the appliance, make sure the voltage indicated on the rating plate is consistent
with the voltage in your home circuit.
• The rating plate with basic information is attached on the lower side of the hob.
• The electric circuit should also include an omnipolar switch that will separate the appliance from
• The electric circuit should also include an omnipolar switch that will separate the appliance from
the mains, if required, with at least 3 mm of distance between contacts. Suitable devices include
fuses, current protection switches, etc.
fuses, current protection switches, etc.
• The connection should be selected according to the installation possibilities with regard to current
and fuses.
• Given the protection from the risk of fi re, appliances of this type may be installed in a worktop
next to a piece of kitchen furniture that is taller than the appliance (when installed); however, in
this case, a kitchen furniture not higher than the cooking hob must be installed on the other side,
adjacent to the appliance.
this case, a kitchen furniture not higher than the cooking hob must be installed on the other side,
adjacent to the appliance.
• The current conducting and isolated parts must be protected from any possibility of direct contact.
Important warnings
18
Connecting the appliance to the power mains