Philips 288P6LJEB 288P6LJEB/27 ユーザーズマニュアル

43

8. Troubleshooting & FAQs

8.  Troubleshooting & FAQs

8.1 Troubleshooting

This page deals with problems that can be 
corrected by a user. If the problem still persists 
after you have tried these solutions, contact 
Philips customer service representative.

 Common Problems

No Picture (Power LED not lit)

! Make sure the power cord is plugged into 

the power outlet and into the back of the 
monitor. 

! First, ensure that the power button on the 

front of the monitor is in the OFF position, 
then press it to the ON position.

No Picture (Power LED is White)

! Make sure the computer is turned on. 

! Make sure the signal cable is properly 

connected to your computer. 

! Make sure the monitor cable has no bent 

pins on the connect side. If yes, repair or 
replace the cable. 

! The Energy Saving feature may be activated

Screen says

Attention

Check cable connection

! Make sure the monitor cable is properly 

connected to your computer. (Also refer to 
»Z@

! Check to see if the monitor cable has bent 

pins. 

! Make sure the computer is turned on. 

AUTO button doesn't function

! The auto function is applicable only in 

VGA-Analog mode. If the result is not 

satisfactory, you can do manual adjustments 
via the OSD menu.

 

Note

The Auto Function is not applicable in DVI-
Digital mode as it is not necessary. 

Visible signs of smoke or sparks

! Do not perform any troubleshooting steps

! Disconnect the monitor from mains power 

source immediately for safety

! Contact with Philips customer service 

representative immediately.

 Imaging Problems

Image is not centered

! Adjust the image position using the “Auto” 

function in OSD Main Controls. 

! Adjust the image position using the Phase/

Clock of Setup in OSD Main Controls. It is 
valid only in VGA mode. 

Image vibrates on the screen

! Check that the signal cable is properly 

securely connected to the graphics board 
or PC. 

[! \ "!!

! Adjust the image using the “Auto” function 

in OSD Main Controls.

! Eliminate the vertical bars using the Phase/

Clock of Setup in OSD Main Controls. It is 
valid only in VGA mode.

! ] \ "!!

! Adjust the image using the “Auto” function 

in OSD Main Controls.