Metabo 6.00080.87 ユーザーズマニュアル

ENGLISH en

9

(continuous beeping). The beeping stops after a 

maximum of 30 seconds or when the trigger is 

released (6).
Causes and remedies:
1. Battery pack almost flat (the electronics 

prevent the battery pack from discharging totally 

and avoid irreparable damage).
If the battery pack is almost flat, it must be 

recharged.

2. Long continuous overloading of the machine will 

activate the temperature cut-out.
Leave the machine or battery pack to cool. 
Note: The machine will cool more quickly if you 

operate it at idling speed.

3. If the current is too high (for example, if the 

machine seizes continuously for long periods), 

the machine switches off.
Switch off the machine at the trigger (6). Then 

continue working as normal. Try to prevent the 

machine from seizing.

6.2 Battery pack
Charge the battery pack before use.
If performance diminishes, recharge the battery 

pack.
The ideal storage temperature is between 10°C and 

40°C.
Removing the battery pack

Press the battery pack release (7) button and 

remove the battery pack (8).
To fit

Slide in the battery back (8) until it engages .

Do not activate rotation selector switch (5) 

unless the motor has completely stopped!

Actuate the rotation selector switch (direction of 

rotation setting, transporting safety device) (5).
See page 2.
R = Clockwise setting

L = Counter-clockwise setting

0 = Middle position: transportation safety device

(Switch-on lock) set

1st gear (low speed,

particularly high torque, preferable for 

screwing)

2nd gear (high speed, preferable for drilling)

6.5 Setting torque control,

Turn selector barrel (torque, drilling) (3).
1...6 =  Torque setting (with torque control) - 

intermediate positions are also possible.

=   Drilling stage setting (max. torque, 

without torque control) 

To avoid motor overloading, do not lock 

the spindle.

To start the machine, press the trigger (6). The 

speed can be changed by pressing in the trigger. 

If you are working with long screw bits or bit holders, 

we recommend the use of the bit clamping bush  (1) 

provided or the bit clamping brush 6.31281 

available as an accessory (see accessories 

Chapter).
Drilling

Preferably in 2nd gear (high speed). 
Screws

Preferably in 1st gear (low speed) and with torque 

control.
Screws in areas that are hard to access

The angle screwdriver attachment (see 

Accessories chapter) greatly facilitates work on 

areas that are difficult to access.
Thread tapping

Lubricate the dies. 

Select 1st gear (low speed). 

Adjust torque control.

Use only genuine Metabo accessories.
If you need any accessories, check with your 

dealer.
For dealers to select the correct accessory, they 

need to know the exact model designation of your 

power tool.
See page 4.

A Quick-clamping chuck. 

Fitting: unscrew protective cap (1). Screw the 

quick-clamping chuck onto the spindle thread. 

The quick-clamping chuck can be tightened 

(and released again) with an open-jawed 

spanner.

B Angle screwdriver attachment.

C Battery  pack

D Battery  charger

E Bit clamping bush

F Bit  box

For a complete range of accessories, see 

www.metabo.com or the main catalogue.

Repairs to electrical tools must be carried out 

by qualified electricians ONLY! 

If you have Metabo electrical tools that require 

repairs, please contact your Metabo service centre. 

For addresses see www.metabo.com.