Lecroy WaveJet 354A 500 MHz 4 Channel Oscilloscope WaveJet 354A データシート

WaveJet 300A Remote Control Manual 

917976 Rev A

The Remote Function uses GPIB, TCP/IP and USB as the interface. GPIB is installed according to IEEE488.1 and 
IEEE488.2, while TCP/IP is installed according to LeCroy VICP. 

The WaveJet remote control interfaces, WJ-A-LAN and WJ-A-GPIB are compatible with all WaveJet units running 
firmware version 3.06 or higher.  For firmware upgrades please visit www.lecroy.com.  The firmware and firmware 
installation instructions are available for download. 

1.  Confirm the installed firmware version is 3.06 or higher.  To do this press U

 on the front panel, select 

Status and Update and then select Update.  If it is 3.06 or greater proceed to step 2.  If not please update the 
firmware. 

2.  With the power off, remove the screws from the rear panel option slot. 

3.  Insert the WJ-A-LAN and/or WJ-A-GPIB interfaces into the slot and fasten the screws.   

4.  Turn the WaveJet power on and then press U

 on the front panel. 

5. In 

the 

Utilities menu a new selection, Remote will be available, if two cards are installed there will be a choice 

between TCP/IP and GPIB.  If only one is installed there will only be one listing. 

6.  For GPIB operation use the A

 knob to set the appropriate GPIB address. 

7.  For TCP/IP use the A

 knob to set the IP address.  Rotate the knob to change values; push the knob to 

jump from field to field.  The WaveJet works with static IP addressing only. 

8.  Press the soft key next to the down arrow to move to Subnet Mask and Default Gateway.  Rotate the knob to 

enter values; push the knob to change fields. 

9.  After entering the correct addresses, press Enter at the bottom of the remote menu and reboot the scope. 

The WaveJet can be operated with both WJ-A-LAN and WJ-A-GPIB installed, or with only one interface card 
installed.  However, two GPIB or two LAN cards cannot be installed simultaneously.