Medisana MTX 51083 ユーザーズマニュアル

4. Press the TIMER button 



and the alarm symbol flashes. Use the MEMO

button 



to switch between alarm on (

) and alarm off (

).

To confirm your entries, press the TIMER button 



or the START button



. Once the alarm has been set, an acoustic signal sounds at the time you

set.

The  MTX gives you the opportunity to assign readings to one of two user
memories, each of which provides 99 memory slots. Switch the device to stand-
by mode. Press the TIMER button 



to select either user memory 1 or user

memory 2 



.

With the MTX, you can choose between two measuring modes.  

• Single reading
• 3 consecutive readings ( Measurement Average Mode = 3/MAM-mode )

In the case of a single reading, just one blood pressure reading is taken and
stored.
The 3/MAM-mode is to be recommended if you suffer from severely fluctu-
ating blood pressure. 3 successive readings are taken at 15 second intervals,
thus eliminating widely varying readings. In the case of serious deviations,
a 4th reading may be taken.
From these three measurements, a weighted average value is calculated,
displayed and stored in the selected memory. A reading taken in this way is
indicated in the memory by an 



.

The 3/MAM procedure greatly minimizes the risk of an incorrect reading.

1. To switch between single measurement and 3 consecutive measurements

(3MAM procedure), press and hold the TIMER button 



until the symbol

for 3MAM mode 

and “

“ appear flashing in the display.

2. Press the MEMO button 



to select either “

“ or “

“; “

“

for the 3MAM measuring method and “

“ for single measurement. 

3. Confirm your selection by pressing the START button 



(or press the

TIMER button 



to make the next setting: “ Switch beep on/off “).

51083_MTX_West_Final_08.06.qxd:Blutdruckmessgerät  08.06.2013  12:39 Uhr  Seite 26