Mikroelektronika MIKROE-350 データシート

Note: Not all the AVR MCUs support both PWM and PWM1 library. The best way to verify this is
by checking the datasheet for the desired MCU. Also you can check this by selecting a MCU in
mikroBasic PRO for AVR looking at the Library Manager. If library manager loads both PWM and
PWM1 library (you are able to check them) then this MCU supports both PWM libraries. Here you
can take full advantage of our Code Assistant and Parameter Assistant feature of our compiler.

312

- SOFTWARE AND HARDWARE SOLUTIONS FOR EMBEDDED WORLD

CHAPTER 6

sub procedure PWM_Stop()

Nothing.

Stops the PWM.

MCU must have CMO module to use this library. PWM_Init and PWM_Start
must be called before 
using this routine using this routine, otherwise it will have no effect as the PWM
module is not running. 

PWM_Stop()

sub procedure PWM1_Init(dim wave_mode as byte, dim prescaler as
byte, dim inverted as byte, dim duty as byte)

Nothing.

Initializes the PWM module. Parameter wave_mode is a desired PWM mode. There
are two modes: Phase Correct and Fast PWM. Parameter prescaler chooses
prescale value N = 1,8,64,256 or 1024 (some modules support 32 and 128, but for
this you will need to check the datasheet for the desired MCU). Paremeter inverted is
for choosing between inverted and non inverted PWM signal. Parameter duty sets
duty ratio from 0 to 255. PWM signal graphs and formulas are shown below.