LG TM2792S-SZ オーナーマニュアル

Unpacking and Exterior of antenna isolator

Connection method

Use this to install TV in a place where there is a voltage difference between GND of power and GND of 
antenna signal. If there is a voltage difference between GND of power and GND of antenna signal, the 
antenna contact might be heated and excessive heat might cause an accident.
You can improve the safety when watching TV by efficiently removing power voltage from TV antenna. Avoid 
disconnecting the antenna Isolator after installation.

“Equipment connected to the protective earthing of the building installation through the mains connection 
or through other equipment with a connection to protective earthing - and to a cable distribution system 
using coaxial cable, may in some circumstances create a fire hazard. Connection to a cable distribution 
system has therefore to be provided through a device providing electrical isolation below a certain 
frequency range (galvanic isolator, see EN 60728-11)”
When applying the RF Isolator, a slight loss of signal sensitivity can occur.

1

  Connect 

Plug 1 with a signal cable.

2

  Connect 

Plug 2 with ANT input end on the back of TV.

y

y

Image shown may differ from your TV.

* Depending on the country