Meridian Data SecurStor iSCSI to SATA-II RAID Subsystem 16i ユーザーズマニュアル
Chapter 5: Subsystem Maintenance and Upgrading
5-19
Step 3.
Keep a replacement on hand: If a hard drive has failed, make sure
you have a replacement drive readily available before removing the
failed drive from the subsystem. Do not leave the drive tray slot
open for an extended period of time or the normalized airflow will
be disrupted and subsystem components will overheat and may
become permanently damaged.
5.7.2 Replacing a Hard Drive
To replace a hard drive, please follow these steps:
WARNING!
Hard drives are fragile; therefore, always handle them with extreme care.
Do not drop the hard drive.
Always be slow, gentle, and careful when handling a hard drive.
Handle a hard drive only by the edges of its metal cover, and avoid touching
its circuits part and interface connectors.
Step 1.
Identify the location of the drive tray that contains a hard drive
indicated as faulty. You may use firmware utility or RAIDWatch
software to locate a faulty drive. The drive tray LED should also
light red.
Step 2.
Make sure the rotary bezel lock is in the unlocked position, i.e.,
the groove on its face is in a horizontal orientation. If the groove is
in a vertical position, as shown below, then the bezel lock is
locked and the front flap on the drive tray cannot be opened.
Figure 5-15: Front View of an Individual Drive Tray