Bunn Ultra-2 ユーザーズマニュアル

4

CAUTION – The dispenser is very heavy! Use care when lifting or moving it. Use at least two people to lift or 

move the dispenser.

3.  Remove the rear plastic plug 

from the trim strip between the 

hopper drip trays and loosen the 

auger motor cover screws.

2.  Remove all shipping material, including the compressor support eyebolt, the cooling drum supports, the 

“Do Not Lift Here” signs from the cooling drums, and the “Rinse Before Using” signs from the hopper(s).

 

4.  Place PAF platform assembly 

on top of the motor covers and 

install support rod into hole in 

trim strip.

6.0”

MIN.

1.   Set the dispenser on a sturdy counter top. The dispenser requires a minimum of 6.0” air clearance at the 

rear of the dispenser. For optimum performance, do not let warm air from surrounding machines blow on 

the ULTRA  dispenser.

NOTE – The dispenser should be level or slightly lower in front for proper operation.

6.  Plug RCA cord into ULTRA base 

unit. Proceed with steps 7 thru 

12.

5.  Tighten support rod from top 

of platform. Retighten motor 

cover screws.

8.  Press the seals firmly into 

place.

7.  Install each hopper seal over 

the flange at the rear of the 

cooling drums as shown.

45246 072611