Sun Lawn MM-2 ユーザーズマニュアル
Owner’s Manual — Sunlawn MM-2
3
ASSEMBLE THE HANDLE SECTIONS
1. Set the cutting height to the highest setting as shown below. This
will make it easier to attach the lower handle section.
will make it easier to attach the lower handle section.
a. Loosen the two large black knobs [Part # 9], one on each side
of the mower body, to allow movement of the height
adjustment arms [Part # 11]. NOTE: the handle is mounted to
the adjusting arms and thus moves with the arms.
adjustment arms [Part # 11]. NOTE: the handle is mounted to
the adjusting arms and thus moves with the arms.
b. Set the height to the highest setting and re-tighten the black
knobs.
2. Fit the lower section of the handle [Part # 4] so that the holes are
over the handle posts on the mower. [See Insert B] Then rock the
handle to align the locking tabs and allow the handle section to fit into
place. Place the spacer [Part # 7] over the post and put the cotter pin
(Part # 8] through the hole to secure the handle.
over the handle posts on the mower. [See Insert B] Then rock the
handle to align the locking tabs and allow the handle section to fit into
place. Place the spacer [Part # 7] over the post and put the cotter pin
(Part # 8] through the hole to secure the handle.
3. Continue assembly of the middle [Part # 3] and top sections [Part
# 1] of the handle using the handle bolts and wing nuts [Part # 5 and
6].
# 1] of the handle using the handle bolts and wing nuts [Part # 5 and
6].
ADJUSTING THE CUTTING HEIGHT
The cutting height of the MM-2 may be adjusted from approximately
1.0 inch up to approximately 2.9 inches. Actual height may vary
according to the height of the turf. Adjust the mower to the desired
height as follows:
1.0 inch up to approximately 2.9 inches. Actual height may vary
according to the height of the turf. Adjust the mower to the desired
height as follows: