Sterling Welder 882.01749.00 ユーザーズマニュアル

882.01749.00  

46 

of 

93 

 

 
Speed Status Indicator 
 
 

If  the speed alarm only option is selected in the configuration section, the following indicators are 

enabled. 
 

  Displays when the feeder speed exceeds the calculated speed by greater than that 

specified on the speed alarm setup screen.  The screen will change to a steady orange color. 
 

  Displayed when the feeder speed is less than that specified on the speed alarm setup 

screen. The screen will change to a steady orange color. 
 
 

  Displayed when no encoder pulses are detected from the drive motor. The screen will 

change to a steady orange color. 
 
 

  Displayed when the calculated motor speed is greater than the rated motor speed. The 

screen will change to orange and flash in this condition. 
 

 Displayed when the calculated motor speed is less than 5% of the rated motor speed. 

The screen will change to orange and flash in this condition. 
 
 
 
 
Disc Motor Indicator 
 
 

   

Displayed when the drive motor is running. 

 
Press Signal Indicator 
 

 

Displayed when press signal is detected: 

 
 

Injection – Screw recovery signal. 

 
 

Simple Extrusion – Press Run signal. 

 
 

Extrusion Follower – Analog speed signal.