Sentry Industries PT22 ユーザーズマニュアル

Logging in through Telnet requires directing the Telnet client to the configured IP address of the unit. 

Logging in through the Console (RS232) port requires the use of a terminal or terminal emulation 
software configured to support ANSI or VT100 and a supported data rate (300, 1200, 2400, 4800, 9600, 
19200, 38400, 57600, or 115200 BPS) - 8 data bits-no parity-one stop bit and Device Ready output 
signal (DTR or DSR). 

1.  Press Enter. The following appears, where x.xx is the firmware version:  

Sentry Version x.xx 
Username:

 

NOTE: Logging in by Telnet will automatically open a session.  It is not necessary to press Enter. 

2.  At the Username: and Password: prompts, enter a valid username and password. And press Enter. 

You are given three attempts to enter a valid username and password combination. If all three fail, 
the session ends. 

NOTE: The default Sentry username/password is admn/admn. 

When you enter a valid username and password, the command prompt (Sentry:) appears. If a location 
identifier was defined, it will be displayed before the Sentry: prompt. See Creating a location 
description

on page 37 for more information. 

Commands may be entered in any combination of uppercase and lowercase. All command characters must 
be entered correctly; there are no command abbreviations. A user must have administrative privileges to 
use the administration commands. The following tables list and briefly describe each command.  

On  

Turns one or more outlets on 

Off  

Turns one or more outlets off 

 

Reboot  

Reboots one or more outlets 

Status  

Displays the on/off status of one or more outlets 

ILoad 

Displays the total cumulative input load 

Istat 

Displays the status of the infeeds 

Connect 

Connects to a serial port 

Envmon 

Displays the status of the integrated Environmental Monitor 

Login  

Ends the current session and brings up the Username: prompt 

Logout 

Ends a session 

Quit  

 

Ends a session 

List Outlets 

Lists all accessible outlets for the current user 

List Ports 

Lists all accessible serial ports for the current user 

List Group 

Lists all assigned outlets for a group name 

List Groups 

Lists all accessible groups for the current user 

Add Grouptouser 

Grants a user access to one or more groups 

Add Outlettogroup 

Adds an outlet to a group name 

Add Outlettouser 

Grants a user access to one or all outlets 

Add Porttouser 

Grants a user access to one or all serial ports 

Create Group 

Adds a group name 

Create User 

Adds a user account  

Delete Groupfromuser  Removes access to one or more groups for a user 

Delete Outletfromgroup  Deletes an outlet from a group name 

Delete Outletfromuser 

Removes access to one or all outlets for a user 

22 

•   Operations 

Sentry PT22 

 

 

 

Installation and Operations Manual