Sennheiser CONFERENCE SYSTEM SDC 8000 ユーザーズマニュアル
Setting up the SDC 8000 system
53
Connecting a PC to the central unit
If your system comprises interpreter consoles, you require a PC with two
serial interfaces:
serial interfaces:
y The conference management software accesses the conference
configuration via the central unit’s COM 3 interface
.
y The interpreter management software accesses the interpreter
configuration via the central unit’s COM 1 interface
.
To connect a PC to the central unit:
왘
Connect one serial interface of the PC to the COM 3 interface
of the
central unit.
왘
Connect the other serial interface of the PC to the COM 1 interface
of
the central unit.
Note!
If you are using more than one central unit, the PC has to be connected
to the “master” central unit.
to the “master” central unit.
For connecting a PC to the central unit, you require the cables shown
below:
below:
Pin 1: Not connected
Pin 2: RX Receive
Pin 3: TX Transmit
Pin 4: Not connected
Pin 5: GND
Pin 6: Not connected
Pin 7: Not connected
Pin 8: Not connected
Pin 9: Not connected
Pin 1: Not connected
Pin 2: RX Receive
Pin 3: TX Transmit
Pin 4: DTR Data Terminal Ready
Pin 5: GND
Pin 6: DSR Data Set Ready
Pin 7: RTS Request to Send
Pin 8: CTS Clear to send
Pin 9: Not connected
PC SUB-D F
PC SUB-D F
5 m