Novatel GNSS Receiver and Antenna SMART-AG ユーザーズマニュアル

The SMART-AG is a high-performance GNSS receiver and antenna, capable of receiving and 
tracking different combinations of GPS L1 and GLONASS L1 code and carrier on a maximum of 36 
channels. SBAS (Satellite Based Augmentation Systems include WAAS, EGNOS, and MSAS) 
support is standard and offers multi-system,and frequency configurations for many application 
requirements. Refer to the GPS+ Reference Manual for an overview of each of the above signal types, 
available from our website at 

http://www.novatel.com/support/docupdates.htm

. The SMART-AG’s 

rear panel also features light emitting diodes (LEDs) for status indication.

The SMART-AG is a single-frequency GNSS receiver. It can optionally be GLONASS-enabled with 
measurements, full code and RTK positioning.

Once you connect the SMART-AG to a vehicle, it begins operating as a fully functional GNSS 
system. Figure 1 below shows the SMART-AG without connecting cables. 

The main features of the SMART-AG and its multicable are:

• An enhanced high performance GPS+GLONASS L1 receiver
• A high performance GPS+GLONASS L1 antenna
• Emulated radar output
• A CAN port 
• Two RS-232 COM ports 
• LED status indicators
• A water and dust tight enclosure

The SMART-AG is available in several different firmware models whose configurations may include 
other additional features. Some possible configurations can be seen in Table 1.