Korg D3200 ユーザーズマニュアル

This button loads (recalls) a mixer setup program.
In the mixer setup list, click the program that you want to 
recall.
Click this button to open the Recall dialog box, verify the 
program that you are recalling, and click the Yes button 
(or press the panel YES key). If you decide not to recall 
the program, click the No button (or press the panel NO 
key).

This button stores the current mixer settings as a mixer 
setup program.
Verify the store-destination number, and click the Yes 
button (or press the panel YES key). If you decide not to 
store, click the No button (or press the panel NO key).

You can click this button and rename the mixer setup 
program (

This selects the store-destination program number. 
Click this cell to highlight it, and then use the value 
dial

 (or +/– keys) to select the desired number.

This displays the settings and status for a single channel.
To select the channel that you want to view, press the CH SE-
LECT

 key and then press the channel key of the desired 

channel.

In this screen you can set the following parameters.

• Pairing (

• Pan (

→p.103)

• Channel on/off (

• Input (

→p.101)

• Attenuator (

→p.107)

• Phase (

• Recording location (

• Solo on/off (

• EQ on/off, flat (

→p.107)

• Fader (

→p.103)

• Level meter position (

• Group (

→p.102)

• Send (

→p.109)

• EQ (

→p.107)

To edit the Send and EQ parameters, use the Knob Matrix lo-
cated below the display.

This displays a simplified signal flow for the channel shown 
in the “Ch View” tab page.
You cannot edit the settings here.
To select the channel that you want to view, press the CH 
SELECT

 key and then press the channel key of the desired 

channel.