Multiquip Sander SFCS-16 ユーザーズマニュアル

 

 

b) To lubricate the exciter bearing housing casting. 
The exciter unit utilizes a sealed type ball bearing. The 
Zerk® fitting provides lubrication for the self-aligning 
feature of the bearing unit. Consult the LUBRICATION 
section for additional information. 
 
Sleeve type bearings  are self-lubricating  and will not 
normally require additional lubrication during their 
normal service life. Ball type bearings  are shielded or 
sealed  and will not normally require additional 
lubrication during their normal service life. 
9) Determine that  all safety decals  and operational 
information decals (including the applicable Quik Tips 
information) is in proper and readable condition. 
Replace  any missing or damaged safety decal and/or 
information decal with a factory approved replacement 
part only. 
 
10) The FLOOR COVERING SCRAPER utilizes 
antivibration handle grips on the operator handle to 
enhance control and help dampen the forces 
experienced during the covering removal process. 
Determine the handle is equipped with properly fitting 
handle grips of sufficient integrity to allow for proper 
job function as outlined in this manual. Loose fitting 
handle grips or grips without end caps should be 
replaced with factory  approved replacement parts 
only. 
 

 

 

DO NOT OPERATE THE FLOOR COVERING 
SCRAPER WITHOUT PROPERLY FITTED HANDLE 
GRIPS OF SUFFICIENT INTEGRITY  INSTALLED 
ON THE OPERATOR HANDLE.  OPERATING THE 
FLOOR COVERING SCRAPER WITH IMPROPER 
OR NO HANDLE GRIPS CAN RESULT IN 
PROPERTY DAMAGE AND/OR PERSONAL 
INJURY. 
 
LUBRICATION REQUIREMENTS. 
 
Parts Required: 
 
1 each, standard grease gun filled with one of the 
following: ESSO Beacon 325, Shell Alvania #2, 
Chevron SRI, or equivalent. 
 
1 each, container of dry film lubricant. 
 
1)  Lubricate the caster wheel bearings with a dry film 

lubricant only. Dry film lubricants dry immediately 
upon contact. Use sparingly. Excess lubricant will 
attract the fine grained, powdered materials 
described and directly affect bearing service life. 

 

 

Do not lubricate the caster wheels with any 
lubricant other than a dry film type. Grease and 
many other liquid type lubricants will attract 
foreign material accumulations that can reduce 
bearing service life. 
2) Zerk™ type grease fittings are provided at two 
locations: 
a) To lubricate the Back Saver™ Blade Control 
System jackscrew. Keep the jackscrew properly 
lubricated to minimize friction when operating the 
blade control lever. Excessive lubrication will attract 
foreign material  accumulations that can reduce 
jackscrew service life. 
FIGURE 32. 
 
b) To lubricate the exciter bearing housing casting. 
The exciter utilizes a sealed type ball bearing. The 
Zerk® fitting provides lubrication for the self-aligning 
feature of the bearing unit. FIGURE 33. Grease 
interval will vary depending upon machine utilization 
rates and operating environment factors.  
 
Sleeve type bearings utilized for the operator handle 
are self-lubricating  and will not normally require 
additional lubrication during their normal service life. 
Ball type bearings  are shielded or sealed  and will not 
normally require additional lubrication during their 
normal service life. 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
FIGURE 32