Multiquip Outboard Motor CV1A ユーザーズマニュアル

Motor Does Not Start

No power to motor?

Verify unit is plugged to proper outlet. Verify 

extension cords are properly plugged in and are 

not cut or pinched. Verify power is available at 

outlet. Check main switch or breaker.

Defective ON/OFF switch?

Replace switch.

Rattling Noise From Rear Of 

Housing Area

Rear bearing failure?

Replace bearing.

Rattling Noise From Shaft End

Worn coupler?

Disconnect coupler and turn motor on. If noise 

goes away, replace coupler. If noise remains, 

check forward bearing.

Forward bearing failure?

Replace bearing.

Flexshaft Binding

Flexshaft kinked?

Straighten out flexshaft.

Defective flexshaft?

Replace flexshaft.

Too much grease in flexshaft 

casing?

Relube flexshaft.

Leaking Vibrator Head

Too much oil in head casing? Fill head casing to recommended level.
Head bearings/seals 

defective?

Replace vibrator head.