Multiquip Appliance Trim Kit MVH406DSCPAS ユーザーズマニュアル

This section is intended to assist the operator with the initial 

start-up of the compactor.  It is extremely important that 

this section be read carefully before attempting to use the 

compactor in the field.
Refer to Figure 3 for the location of controls and components.
Releasing the Handle
1.  Pull the handle release pin, (Figure 11) then push down 

on the hand grip to release the handle.

dO nOT attempt to operate the compactor 

until the Safety, General Information and 

Inspection sections of this manual have 

been read and thoroughly understood. 

HANDLE

RELEASE

PIN

PULL UP

TO RELEASE

HANDLE

The height of the handle is adjustable for your comfort .
1.  Loosen the butterfly screw (Figure 12).
2.  Turn the grip clockwise to raise the handle or 

counterclockwise to lower the handle.

3.  When the handle is raised to the desired height, tighten 

the butterfly screw.

Electric Start (Option)
4.  Place the throttle lever (Figure 13) in the START 

position (center). Place the travel lever in the neutral 

position (center).

5.  Insert the ignition key into the ignition switch and turn 

it to the

 Run position (Figure 14). The buzzer should 

sound at this time. 

6.  Turn the  ignition key further to the right to the 

position to start the engine. Buzzer stops sounding and 

the engine starts.

START

(CENTER POSITION)

THROTTLE

LEVER

NEUTRAL

FORWARD

REVERSE

TRAVEL

LEVER