Multiquip Appliance Trim Kit MVH-304DSB ユーザーズマニュアル
PAGE 16 — MQ-MIKASA MVH-304DSB PLATE COMPACTOR — PARTS & OPERATION MANUAL — REV. #2 (11/16/05)
MVH-304DSB — PRE-INSPECTION
Checking Engine Oil Level
1.
Make sure that the machine is situated in a flat
surface so that level measurements will be accurate.
surface so that level measurements will be accurate.
2.
Pull out the dipstick from the oil tank (Figure 5).
Checking The Fuel
1. Remove the fuel cap located on top of fuel tank.
2. Visually inspect to see if fuel level is low. If fuel is low,
1. Remove the fuel cap located on top of fuel tank.
2. Visually inspect to see if fuel level is low. If fuel is low,
replenish with diesel fuel (Figure 6).
3. When refueling, be sure to use a strainer for filtration.
DO NOT top-off fuel. Wipe up any spilled fuel.
Figure 6. Refueling
Fuel spillage on a hot engine can cause a
fire or explosion. If fuel spillage occurs,
wipe up the spilled fuel completely to
prevent fire hazards.
fire or explosion. If fuel spillage occurs,
wipe up the spilled fuel completely to
prevent fire hazards.
NEVER! smoke
around or near the compactor.
DANGER
CAUTION :
NEVER operate the
compactor in a confined area
or enclosed area structure
that does not provide ample
free flow of air.
free flow of air.
ALWAYS wear approved eye and hearing
protection before operating the compactor.
protection before operating the compactor.
Before Starting
1.
Read safety instructions at the beginning
of manual.
of manual.
2.
Familiarize yourself with the operating
and control elements of the machine
and the working environment. This includes obstacles in
the working area, bearing capacity of the ground and the
necessary safety provisions.
and control elements of the machine
and the working environment. This includes obstacles in
the working area, bearing capacity of the ground and the
necessary safety provisions.
3.
Check the air filter for dirt and dust. If air filter is dirty, replace
air filter with a new one as required.
air filter with a new one as required.
4.
Check fastening nuts and bolts for tightness. Loose threads
may cause damage to the machine when vibrating.
may cause damage to the machine when vibrating.
5.
Understand the geographical features and regulations ofthe
job site.
job site.
6.
Clean the compactor, removing dirt and dust. Particularly,
the bottom of the plate, engine cooling air inlet.
the bottom of the plate, engine cooling air inlet.
Figure 5. Oil Dipstick Removal
3. If the oil level is low, fill to the edge of the oil filler hole with the
recommended oil type (Table 4). Maximum oil capacity is
1.74 quarts (1.65 liters).
1.74 quarts (1.65 liters).
DO NOT overfill oil tank. This could cause oil
leaks and sluggish operation. Clean cap and
surrounding area before opening to prevent dirt
from entering tank.
leaks and sluggish operation. Clean cap and
surrounding area before opening to prevent dirt
from entering tank.
CAUTION :
e
p
y
T
li
O
.
4
e
l
b
a
T
n
o
s
a
e
S
e
r
u
t
a
r
e
p
m
e
T
e
p
y
T
li
O
r
e
m
m
u
S
r
e
h
g
i
H
r
o
C
°
5
2
0
3
-
W
0
1
E
A
S
ll
a
F
/
g
n
i
r
p
S
C
°
0
1
~
C
°
5
2
0
2
/
0
3
-
W
0
1
E
A
S
r
e
t
n
i
W
r
e
w
o
L
r
o
C
°
0
0
1
-
W
0
1
E
A
S
Explosive Fuel
DANGER
Diesel fuel is highly flammable and can be
dangerous if mishandled. DO NOT smoke while
refueling. DO NOT attempt to refuel the compactor
if the engine is
dangerous if mishandled. DO NOT smoke while
refueling. DO NOT attempt to refuel the compactor
if the engine is
hot! or running.