Motorola 2.1 ユーザーズマニュアル

Chapter 2: Network Setup  

Select the Install software automatically radio button from the Hardware Update Wizard 
and click Next 

Be sure the hardware update wizard locates the HP NC7782 Gigabit Server driver on the HP 
Smart Start CD

 follow the wizard prompts to install the driver. 

After the first driver is installed, repeat steps 8-10 to continue configuring the second Ethernet 
Controller. 

 

The end result will be two configured network adapters. However, 
AFTER the Ethernet Controller drivers are configured, the next step is to 
configure a single LAN network connection (as described in the 
following steps). 

Select Start | Control Panel | Network Connection | Local Area Connection 

Select Properties button from Local Area Connection Status window 

Highlight the Internet Protocol (TCP/IP) line and select Properties. 

In the Internet Protocol (TCP/IP) Properties panel: 

Select the Use the following address radio button 

Enter an IP address of 172.31.0.21. 

Enter a Subnet mask of 255.255.0.0 

Enter a Default gateway of 172.31.0.2 

Select the Use the following DNS server addresses radio button 

Enter a Preferred DNS server address of 172.31.0.20 

Click the OK button 

The following procedure provides installation instructions for Windows 2003 Support Tools. 

Re-insert the Windows 2003 Server Installation media. 

Be sure NOT to trigger a re-install or update of Windows 2003. 

Select the Perform Additional Tasks option. 

Select Browse this CD. 

Enter the \Support\Tools\ folder. 

Double-click on SUPTOOLS.MSI and follow all on-screen instructions. 

2-24