Motorola 2.1 ユーザーズマニュアル

Chapter 3: MOTOMESH Duo Hardware  

 

Figure 3-2 details the following ports and connections: 

 

•  PWR (power port) 

•  5.8 GHz Antenna Port (Female N-Type connector)

 

•  ETH (Standard Ethernet port.  This port is not capable of sourcing power.  This port 

can be used to connect IP enabled devices that do not require PoE.) 

•  POE OPT (This port is capable of sourcing power over Ethernet (802.3af PoE) or 

Canopy Connect (PoE) when a personality plug is attached to the Select port.)   

 

 

The POE OPT port is by default the “backhaul port” when a MOTOMESH Duo device is operating as an 
IAP.  The backhaul detection mechanism is configured to look for a physical and logical connection on 
this port.  This detection mechanism can be configured via the webpage or One Point Wireless 
Manager

™

 application to use the standard ETH port if desired.  Thus, when deploying IAPs the POE 

OPT port should be used by default to connect to the switch / router supporting network.  Note that in this 
configuration a personality plug will NOT be connected to the Select port and NO power will be sourced 
on the POE OPT port.  If the IAP is being backhauled by a wireless bridge such as a Motorola Canopy

™

 

system then a personality plug may be connected to the Select port and source power on the POE OPT 
port to power the Canopy backhaul radio. 
 

 
 
 
 
 

 

 

Standard 

Ethernet 

5.8 GHz Antenna Port

PoE  

Capable 
Ethernet 

Port 

 
 
 
 
 
 
 
 
 
 
 
 

Power Port 

 
 

3-3