Mitsubishi Electronics Mitsubishi Digital Electronics Water System SW1DNC-GXW2-E ユーザーズマニュアル
3.2.7 Compiling a program
3 - 19
1
OV
E
R
VI
EW
2
CRE
A
T
E
D
PROGRAM
AN
D SYS
TEM
CONF
IGURA
TION
3
CR
EA
TI
NG PR
O
G
R
A
M
IN
S
TRUC
TUR
E
D
L
A
DDE
R/
FB
D
LA
NG
UA
G
E
4
CREA
T
ING
PROG
RAM IN ST
LANGUAGE
5
CRE
A
TI
NG T
W
O OR
MORE PROGRAM
BLO
C
K
S
3.2 Creating a Project
3.2.7
Compiling a program
There are two types of compiling shown below. The compile target is different between the two types.
Select "Rebuild All" here.
The "Rebuild All" procedure is described below.
Refer to the following manual for compiling:
Select "Rebuild All" here.
The "Rebuild All" procedure is described below.
Refer to the following manual for compiling:
GX Works2 Version 1 Operating Manual (Structured Project)
Table 3.1 Compiling type and target program
Target program to be compiled
Build
Converts non-compiled program blocks among program blocks registered in the task into
sequence program. (Does not compile already compiled program blocks.)
sequence program. (Does not compile already compiled program blocks.)
Rebuild All
Converts all program blocks registered in the task into sequence program.
(Compiles already compiled program blocks also.)
(Compiles already compiled program blocks also.)
1.
Select [Compile]
[Rebuild All] to execute
"Rebuild All".
You can click
(Rebuild All) to execute "Rebuild
All".
2.
The screen shown on the left appears.
Click the
button to execute "Rebuild All".
If an error is detected, the Output window is
displayed.
displayed.
• Make sure to compile the created or edited program to make it a sequence program executable in the
programmable controller CPU.
• "Warning C9062" is compiled correctly as a program, and can be monitored.
• Compile status checking method
• Compile status checking method
You can check the compile status on the Project view.
Each non-compiled portion is displayed in red.