Matrox Electronic Systems II ユーザーズマニュアル
42 Chapter 2: Hardware installation
Matrox Meteor-II /1394
Matrox Meteor-II /1394 has four connectors, which are
indicated in the diagram below. Three of these connectors are
located on its bracket, and are discussed in detail in Appendix
E.
indicated in the diagram below. Three of these connectors are
located on its bracket, and are discussed in detail in Appendix
E.
■
1394 ports. Used to provide bi-directional serial
communication and power. Each I/O port features a standard
6 pin connector. See Appendix E for pinouts.
communication and power. Each I/O port features a standard
6 pin connector. See Appendix E for pinouts.
■
Auxiliary power supply input. Used to route power from
your computer through the Matrox Meteor-II /1394 board to
your camera.
your computer through the Matrox Meteor-II /1394 board to
your camera.
Connecting a device to Meteor-II /1394
Connect devices to Matrox Meteor-II /1394’s ports, using the
6-pin connectors. The cable for the Meteor-II /1394 is not
available from Matrox, but 1394 devices, such as cameras,
typically include a cable. See Appendix E for the pinouts,
signals, and mating connector supplier.
6-pin connectors. The cable for the Meteor-II /1394 is not
available from Matrox, but 1394 devices, such as cameras,
typically include a cable. See Appendix E for the pinouts,
signals, and mating connector supplier.
1394
ports
PCI connector
Auxiliary power
supply input