Marantz Mrantz DLP Projector VP-11S2 ユーザーズマニュアル

OSD position is selected from 9 positions.

Enable: Displays the current status of the projector for a set amount of time in the upper right-hand

corner of the screen at startup and whenever the Input Source, Picture Mode, Aspect ratio or
other setting is changed.

Disable: Does not display Status Info.

Disable:

Directly puts the projector on standby without displaying the confirmation message when power
is shut off from the 

button on the remote controller or the 

/I button on the projector.

Enable:

Displays a confirmation message asking whether to shut the power off or continue use
when power is shut off from the 

button on the remote controller or the 

/I button on the

projector. To shut off the power immediately, select “Yes” and press the ENTER button. To
not shut off the power, select “No” and press the ENTER button.

Sets the blanking mode with which part of the screen can be hidden in black bands. To use this mode
or change the setting, select from Memory 1 to 3.

Off:

Turns the blanking mode off. No masking occurs.

Memory 1-3:

Memorize the blanking width of the top, bottom, left and right masks set with the
below features. Up to three settings can be memorized.

Standard 1

Menu Position

Language

Status Info.

Power-OFF Confirm.

Blanking Memory

Blanking Top

Top-L

English

Enable

Disable

Memory 1

0

0

0

0

Blanking Bottom

Blanking Left

Blanking Right

Picture Adjust

Fine Menu 1

Fine Menu 2

Input Signal

RGB/HD Adjust

Display

OSD/Blanking

Config.

HDMI

Set the blanking width of the top, bottom, left and right masks, which are then memorized in Memory 1
– 3 of Blanking Memory. Each can be set from 0 (no mask) to a maximum 100.

VP-11S2_U_01_ENG  07.8.27  10:47 AM  ページ29