Harbor Freight Tools Auto Darkening Welding Helmet with Racing Stripe Design 製品マニュアル
Page 9
Fo r t e c h n i c a l q u e s t i o n s , p l e a s e c a l l 1 - 8 8 8 - 8 6 6 - 5 7 9 7 .
Item 61612
Ma i n t e n a n c e a n d Se r v i c i n g
Pr o c e d u r e s n o t s p e c i f i c a l l y e x p l a i n e d
i n t h i s m a n u a l m u s t b e p e r f o r m e d
o n l y b y a q u a l i f i e d t e c h n i c i a n .
TO PREV ENT SERIOU S INJ U RY FROM TOOL FAIL U RE:
D o n o t u s e d a m a g e d e q u i p m e n t . If a b n o r m a l n o i s e o r v i b r a t i o n
o c c u r s , h a v e t h e p r o b l e m c o r r e c t e d b e f o r e f u r t h e r u s e .
L e n s a n d H e l m e t Ma i n t e n a n c e
Replace the Front Lens Cover if it is damaged
(cracked, scratched, soiled or pitted).
1.
To Re p l a c e t h e Co v e r :
a. Remove the Front Lens Cover by gently
a. Remove the Front Lens Cover by gently
pulling up the central part of the Lens.
See Figure E. If the unit has a frame over
the front of the lens, lift up on the tab at the
bottom of the frame to access the lens cover.
b. Remove the protection film from both sides of
the new Lens if it comes with a film covering.
Place the new Lens into place by bending it
slightly and sliding it between the tabs at each
side of the lens until it snaps into place.
c. Make sure that the Lens is securely installed.
If the unit has a frame, make sure that the
frame is snapped securely into place.
2.
Cl e a n t h e Fi l t e r L e n s with a clean
lint-free tissue or cotton cloth.
3.
D o n o t i m m e r s e the lens in water or
any other liquid. Do not use abrasives,
solvents or oil based cleaners.
4.
D o n o t r e m o v e the Auto-Darkening
Filter from the Auto-Darkening Welding
Helmet. Do not try to open the Filter.
5.
Storage temperature: - 4° to 158° F.
Fi g u r e E
SAFETY
OPERA
TION
MAINTENANCE
SPECIFICA
TIONS