Behringer Digital Mixer X32 ユーザーズマニュアル

X32 DIGITAL MIXER Preliminary User Manual

32 in / 8 out
This mode is tailored to suit a typical studio and overdub recording situation, 

with many input channels but only a few output channels for monitoring of 

previously recorded takes.

8 in / 32 out
This is a useful mode for utilizing the excellent audio engine and effects 

processing of the console during final mixdown of your project. All 32 tracks 

would be fed from your DAW into the console where all the magic happens. 

Then only 2-8 tracks of the complete mixdown would be sent back to the DAW.

If you don’t actually need more than 16 concurrent input and output tracks to 

be exchanged between the console and your PC, then this mode might be more 

appropriate for you. First, it will slow the required bandwidth on the interface 

down.  Second, there will be no excessive I/O tracks in your DAW configuration 

that might clutter your setup. Third, it allows you to run a fully-featured 

zero-latency overdub setup, which would be impossible if signals were run 

through the computer. In this case, the 16 input signals are put on channels 

1-16, while the tape (card) returns are put on channels 17-32. The monitoring is 

directly fed from Ch1-16 as usual, including all processing and effects. It remains 

independent from any computer audio latency, even though you can hear back all 

the recorded tracks without any repatching.