Becker Designed AVIONTM 8528A ユーザーズマニュアル

5

These steps are to be followed after you have unpackaged and completed the simple assembly instructions for your Avion or 

Avion Noir stand.  Due to jostling in freight or perhaps an uneven floor, the doors and drawers on your Avion stand may not 

appear to be in perfect alignment.  Making a few minor adjustments can rectify this situation.  Be aware that depending on 

your situation, patience and a bit of trial and error are required.  The high-quality European hinge hardware is infinitely 

adjustable, but changing one element can cause the need for further adjustments.  Through a little adjustment, you can 

modify the orientation of the cabinet doors to make sure that they are sitting perfectly on your Avion unit.

The levelers which are concealed within the legs can be adjusted from inside the 

Avion cabinet to compensate for an uneven floor or to secure your cabinet so that it 

does not roll.  If you are having difficulty with misaligned doors, it is recommended 

that you first retract all levelers and make sure that the unit is resting on it’s wheels.  

If the center section on a three-legged unit appears to be sagging (center doors 

hangs below the side doors) raise the levelers on the center leg to compensate for 

this.

The doors on your Avion stand should be perfectly spaced 

and the doors should open and close freely without 

rubbing against the door frame.  Adjustments may be 

made to the Avion door hinges with the use of a Phillips 

head screwdriver.  The hinge hardware has three 

adjustment screws. 

•  By adjusting Screw 1, the door will move left and right 

within the frame. For best results, make minor adjustments 

to top and bottom hinge for best results.  

•  If adjusting Screw 1 has not achieved the desired result, 

you can adjust Screw 2 and the door will move up and 

down within the frame (the top and bottom hinges need to 

be adjusted the same amount).

•  Adjusting Screw 3 will cause the entire door to move 

in and out, opening and closing the gap between the door 

frame and cabinet.  This screw rarely needs adjustment.

INCORRECT! Door is 

out of alignment with 

the rest of the unit.

CORRECT! Door is 

sitting squarely and 

evenly spaced on tops 

and sides.

HIGH PERFORMANCE FURNITURE