Marantz AV Pre Tuner AV7005 ユーザーズマニュアル
11
Basic version
Advanced version
Information
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
SVENSKA
Simple version
Set up speakers (Audyssey® Auto Setup)
15
Unplug the setup microphone from
the unit’s SETUP MIC jack.
16
Set Dynamic Volume®.
[6/6]
Finish
Storing complete.
Auto Setup is now
finished. Please unplug
microphone.
Turn on Dynamic Volume?
AUTO SETUP
AUDYSSEY AUTO SETUP
ENTER
Exit
Turn Dynamic Volume on and exit Auto Setup
Yes
No
MultEQ XT
• For details of Dynamic Volume settings, see
page 75.
n
When turning Dynamic Volume on
Use
o
to select “Yes“, and then press
ENTER
.
• The unit automatically enters “Heavy” mode.
n
When turning Dynamic Volume off
Use
p
to select “No“, and then press
ENTER
.
NOTE
After performing Audyssey Auto Setup, do not
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
change the speaker connections or subwoofer
volume. In event of a change, perform Audyssey
Auto Setup again.
Finish
Error messages
An error message is displayed if Audyssey® Auto Setup could not be completed due to speaker placement, the measurement environment, etc. If this happens,
check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.
check the relevant items, be sure to take the necessary measures, then perform Audyssey Auto Setup over again.
NOTE
Be sure to turn off the power before checking speaker connections.
Examples
Error details
Measures
Caution!
No microphone or Speaker
Retry
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP
RETURN
Cancel
MultEQ XT
• The connected setup microphone is broken, or a
device other than the supplied setup microphone is
connected.
connected.
• Not all speakers could be detected.
• The front L speaker was not properly detected.
• The front L speaker was not properly detected.
• Connect the included setup microphone to the
SETUP MIC jack of this unit.
• Check the speaker connections.
Caution!
Ambient noise is too high
or Level is too low
Retry
Check cause of problem!
AUTO SETUP
AUDYSSEY AUTO SETUP
RETURN
Cancel
MultEQ XT
• There is too much noise in the room for accurate
measurements to be made.
• Speaker or subwoofer sound is too low for accurate
measurements to be made.
• Either turn off any device generating noise or move
it away.
• Perform again when the surroundings are quieter.
• Check the speaker installation and the direction in
• Check the speaker installation and the direction in
which the speakers are facing.
• Adjust the subwoofer’s volume.
Caution!
Check cause of problem!
Retry
Front R
None
AUTO SETUP
AUDYSSEY AUTO SETUP
RETURN
Cancel
MultEQ XT
• The displayed speaker could not be detected.
• Check the connections of the displayed speaker.
Caution!
Check cause of problem!
Retry
Skip
Front L
Phase
AUTO SETUP
AUDYSSEY AUTO SETUP
RETURN
Cancel
MultEQ XT
• The displayed is connected with the polarities
reversed.
• Check the polarities of the displayed speaker.
• For some speakers, this error message may be
• For some speakers, this error message may be
displayed even if the speaker is properly connected.
If you are sure the connection is correct, press
If you are sure the connection is correct, press
ui
to select “Skip”, then press
ENTER
.
Remote control operation
buttons
Move the cursor
(Up/Down/Left/Right)
(Up/Down/Left/Right)
Confi rm the setting
Return to previous menu
1.AV7005U_ENG.indd 11
2010/08/23 18:32:09