Marantz AV Pre Tuner AV7005 ユーザーズマニュアル
31
Simple version
Advanced version
Information
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
ESPAÑOL
NEDERLANDS
SVENSKA
Basic version
Tuning in radio stations
n
Checking the SIRIUS signal strength and radio
ID
1
Press
STATUS
until
“SIGNAL” appears on the
display.
The display will switch as
shown below, depending on the
reception conditions.
shown below, depending on the
reception conditions.
Display
Status
EXCELLENT
Signal strength is excellent
GOOD
Signal strength is good
WEAK
Signal strength is weak
NO SIGNAL
No signal
2
Adjust the position of the antenna until “SIGNAL:
EXCELLENT” is shown on the display.
3
Press
STATUS
until the channel (example: “SR001”)
is displayed.
4
Press
TUNING +
or
TUNING –
and select channel 0 (SR000).
Channel No. and Sirius ID are alternately
shown on the display.
shown on the display.
SR000 SiriusID
************
Sirius ID
• Write your own SIRIUS ID for storage use.
Sirius ID :
The strength of both the SIRIUS satellite and terrestrial signals can be
checked “Antenna Aiming” (vpage 68).
n
Presetting radio channels (Preset memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
tune them in easily. Up to 56 channels can be preset.
1
Tune in the broadcast channel
you want to preset.
2
Press
MEMORY
.
3
Press
SHIFT
to select the block
(A to G) in which to preset the
channel (1 to 8 per block), then
press
PRESET +
,
PRESET –
or
1 –
8
to select the preset number.
4
Press
MEMORY
again to complete
the setting.
• To preset other stations, repeat steps 1 to
4.
NOTE
Preset channels are erased by overwriting them.
n
Listening to preset channels
Press
PRESET +
,
PRESET –
to select
the desired preset channel, then press
ENTER
.
• Preset channels can also be selected by
pressing
SHIFT/TOP MENU
(Block) and
1 –
8
(Channel).
You can also operate via the main unit. In this
case, perform the following operations.
Press o p to select the preset radio channel.
case, perform the following operations.
Press o p to select the preset radio channel.
n
Searching categories
1
Press
o
p
.
SR001 Hits 1
CAT : Pops
Channel category
2
Use
o
p
to select the category, to use
ui
to select
the desired channel.
n
Accessing SIRIUS satellite radio channels
directly
1
Press
SEARCH/INFO
.
2
Press
0 – 9
to input the channel.
Example: Accessing channel “SR123”:
Press
Press
1
,
2
and
3
.
• If no button is pressed within several
seconds,
the
channel
automatically
switches to the one whose number has
been input.
been input.
3
Press
ENTER
to set that channel.
Reception switches to the selected
channel.
channel.
• “UPDATING” is displayed while the encording code is being
updated.
• “SIRIUS UPDATING” is displayed when updating SIRIUS tuner
firmware.
• Refer to “Troubleshooting” – “SIRIUS Satellite Radio” (vpage 113)
regarding other messages.
1.AV7005U_ENG.indd 31
2010/08/23 18:32:37