Multi Tech Equipment MultiModemZBA MT5634ZBA-V-V92 ユーザーズマニュアル

automode An optional numeric value that enables or disables automatic

modulation negotiation using V.8 bis/V.8 or V.32 bis Annex A.
Automode is disabled if values are specified for the 

max_rate

and 

max_rx_rate parameters. The options are:

0 Disable automode
1 Enable automode (default)

max_rate An optional number that specifies the highest rate at which the

modem may establish an upstream (transmit) connection. The
value is decimal coded in units of bps, for example, 33600
specifies the highest rate to be 33600 bps.

0 Maximum rate determined by the modulation selected in 

mod

(default).

300–33600 Maximum rate value limited by the modulation selected in 

mod.

For valid 

max_rate values for each mod value, see the follow-

ing table.

V21, Bell103

300

V22, V23C, Bell212A

1200

V22B

2400

V32

14400, 12000, 9600, 7200, 4800

V32B

19200, 16800, 14400, 12000, 9600, 7200, 4800

V92, V90, V34

33600, 31200, 28800, 26400, 24000, 21600,19200, 16800,

14400, 12000, 9600, 7200, 4800, 2400

max_rx_rate An optional number that specifies the highest rate at which the

modem may establish a downstream (receive) connection. The
value is decimal coded in units of bps, e.g., 28800 specifies the
highest rate to be 28800 bps.

0 Maximum rate determined by the modulation selected in 

mod

(default).

300–56000 Maximum rate value limited by the modulation selected in 

mod.

See “Possible rates” in the 

mod table.

Command: +PCW=

Values:

n = 0, 1, or 2

Default:

2

Description:

Controls the action to be taken upon detection of a call waiting
tone in V.92 mode. Values specified by this command are not
modified when an AT&F command is issued.

+PCW=0 Toggles V.24 Circuit 125 and collects Caller ID if enabled by

+VCID

+PCW=1 Hangs up
+PCW=2 Ignores V.92 call waiting
+PCW=? Displays the allowed values
+PCW?

Displays the currrent value