Multi Tech Equipment MultiModemZBA MT5634ZBA-V-V92 ユーザーズマニュアル
8 Solving Problems
74
MultiModemZBA-V-V92 User Guide
Chapter 8 - Solving Problems
Your modem was thoroughly tested at the factory before it was shipped. If you are unable to make a
successful connection, or if you experience data loss or garbled characters during your connection, it
is possible that the modem is defective. However, it is more likely that the source of your problem lies
elsewhere. The following symptoms are typical of problems you might encounter:
successful connection, or if you experience data loss or garbled characters during your connection, it
is possible that the modem is defective. However, it is more likely that the source of your problem lies
elsewhere. The following symptoms are typical of problems you might encounter:
•
None of the LEDs light when the modem is on.
•
The modem does not respond to commands.
•
The modem cannot connect when dialing.
•
The modem disconnects while online.
•
The modem cannot connect when answering.
•
File transfer is slower than it should be.
•
Data is being lost.
•
There are garbage characters on the monitor.
•
The modem doesn’t work with Caller ID.
•
Fax and data software can’t run at the same time.
If you experience problems, please check the following possibilities before calling Technical Support
(see Appendix D).
(see Appendix D).
None of the Indicators Light
When you turn on the modem, the LED indicators on the front panel should flash briefly as the
modem runs a self-test. If the LEDs remain off, the modem is probably not receiving power.
modem runs a self-test. If the LEDs remain off, the modem is probably not receiving power.
Ö
Make sure the modem’s power switch is on, especially if you normally turn the modem on by
turning on a power strip.
Ö
If the modem is plugged into a power strip, make sure the power strip is plugged in and its power
switch is on.
Ö
Make sure the power supply is firmly connected to the modem and the power supply’s power
cord is firmly connected to both to the power supply and the wall outlet or power strip.
Ö
If the power strip is on and the modem switch is on, try moving the power supply to another
outlet on the power strip.
Ö
Test that the outlet is live by plugging another device, such as a lamp, into it.
Ö
The modem or power supply may be defective. If you have another Multi-Tech modem, try
swapping modems. If the problem goes away, the first modem or power supply might be
defective. Call Technical Support for assistance.
defective. Call Technical Support for assistance.
CAUTION: Do not under any circumstances replace the power supply with one designed for another
product; doing so can damage the modem and void your warranty.
product; doing so can damage the modem and void your warranty.