Motorola Automobile Accessories F5218 ユーザーズマニュアル
14
MW810 Mobile Workstation Vehicle Installation Manual
• Verify that the cables are of sufficient length. Do not connect two short lengths with a
connector; doing so will result in signal loss. Refrain from loose excess in the cables, but
leave enough slack to allow reconnecting if necessary.
• Do not run cables externally or underneath floor mats.
• Do not locate cables where they can be kicked by the driver or passengers or where they
• Do not locate cables where they can be kicked by the driver or passengers or where they
can interfere with operation of the driver’s foot pedals.
• When routing the cable, refrain from creating sharp bends or kinks.
• Cables longer than 10 ft. (3.05 m) should be routed through special UL listed conduit/duct
• Cables longer than 10 ft. (3.05 m) should be routed through special UL listed conduit/duct
for electrical cables. This conduit/duct should fully enclose the cable along its whole
length.
• Do not overtighten any tie wraps.
12.1“ Display
The 12.1 display is attached to the display mount by Phillips screws (10mm, M4), supplied in
the display shipping package. The CPU to Display Signal Cable is routed from the CPU Box,
through the mount, and connected to the lower back side of the display (see Figure 9).
Form a service loop for the Power and Display Signal Cables to reduce cable tension. Use
plastic cable tie wraps to secure the cables to cable tie points. Do not overtighten the tie
wraps.
Use caution when connecting the display to CPU cable. Rough
installation may damage the connectors/receptacles of the display,
cable or CPU Box.
To interface the MW810 R2.0, 12.1” Display to a legacy MW810 CPU
Box, use CPU Box to Display R2.0 to Display (50 pin to 60 pin) adaptor
cable - P.N: FKN00010.
When interfacing the MW810 R2.0, 12.1” Display to a legacy MW810
CPU Box, software installation is also required. (See MW810 Mobile
Workstation, R2.0, Administrator Guide P.N 6802988C42.)
The Function keys of the display include an illuminated area designed
for description labels. Contact your Motorola Solutions representative
for assistance ordering custom-made labels as needed.
!
Caution
Note
Note