Motorola Automobile Accessories F5218 ユーザーズマニュアル

MW810 Mobile Workstation Vehicle Installation Manual

To ensure a secure connection of an antenna cable's mini-UHF plug to W-WAN mini-UHF

jacks, their interlocking features must be properly engaged. If they are not properly engaged,

the plug will come loose. Using a tool (pliers or wrench) will not overcome a poor

engagement, and is not recommended.

W-LAN Radio Antenna Connection

Connect the reversed thread SMA plug of the antenna RF cable to the W-LAN jack on the

expansion board.
For best 802.11a/b/g/n coverage and communication performance, connect WLAN MIMO

antenna to all three antenna jacks.

Important Note:

If only one antenna is used, always connect the antenna to the “1” jack

of W-LAN.

Recommended W-LAN antenna: PCTEL Multi-Band Mobile Low Profile MIMO Antenna

PCTEL P.N: Z3352.

GPS Antenna Connection

The MW810 Mobile Workstation may be supplied with an optional internal module of

Global Positioning System (GPS). Connect the cable connector of the GPS antenna to the

GPS connector at the rear panel of the CPU Box, on one side, and to the connector of an

active GPS antenna on the other side.
To install the GPS antenna to the vehicle, refer to the installation instructions of the antenna

manufacturer.
Recommended antenna: PCTEL, 35dB stud mount antenna with jam nut. Motorola Solutions

P.N: FAG5027.

Video In Connection

Standard Composite CVBS video input. The MW810 Mobile Workstation is equipped with a

BNC type connector to which a video camera can be connected. A BNC to RCA adapter

(P.N: 5802810C07) is also available from Motorola Solutions. 

Important Note:

the Video In input is only supported in the “Extra Display, Video & I/O

Expansion Board” expansion board option of the CPU Box.

The connector type of all W-LAN jacks are reverse polarity reverse

thread SMA. To secure the plug, turn counterclockwise. To release the

plug, turn clockwise.

When a SBR-LS GPS Module is used, dead reckoning intelligence can

be achieved only if vehicle speed (SPEED+ and SPEED-) and

direction (FWD+, FWD-) inputs are connected to the auxiliary port of

Note