Bunn FPG-2 ユーザーズマニュアル

35

P1300

Location:

 

The Urn/Carafe switch is located to the left side on 

the front of the housing above the upper inspection 

panel.

Test Procedure:

1.  Disconnect the grinder from the power supply.

2.  Remove the tan, yellow and green wires from the 

switch.

3.  Place the switch in the “CARAFE” position; check 

for continuity across the pink and the tan wire 

terminals, also across the orange and the yellow 

wire terminals.

If continuity is present as described in both checks, 

proceed to step 4.

If continuity is not present as described in one or both 

of the checks, replace the switch.

TAN

PNK

YEL

ORA

GRN

P1318

4.  Place the switch in the “URN” position; check for 

continuity across the orange and green wire  ter-

minals. 

If continuity is present as described, the switch is 

operating properly.

 

If continuity is not present as described, replace 

the switch.

Removal and Replacement:

1. 

Remove all the wires from the switch terminals.

2. 

Compress the clips inside the housing and gently 

push the switch through the opening.

3. 

Push the new switch into the opening and spead 

the clips to hold the switch in the housing.

4. 

Refer to the illustration below when reconnecting 

the wires.

FIG 30 URN/CARAFE SWITCH

FIG 31 URN/CARAFE SWITCH TERMINALS

P1318

41545 122209