Maxon Telecom Modem MM-6280IND ユーザーズマニュアル

 

 

HSDPA Standard At Commands        Page 29 of 60                             Version 1.2 

 

 

 

Action command sets a new password for the facility lock function defined by command Facility 
Lock +CLCK. 

+CPWD=<fac>,<oldpwd>,

<newpwd> 

+CME ERROR: <err> 

+CPWD=? +CPWD: 

list of supported (<fac>,<pwdlength>)s 

+CME ERROR: <err> 

value 

<fac>

:  

"P2"

 SIM 

PIN2 

 refer Facility Lock +CLCK for other values 

<oldpwd>

, <newpwd>: string type; <oldpwd> shall be the same as 

password specified for the facility from the MT user interface or with 
command Change Password +CPWD and <newpwd> is the new password; 
maximum length of password can be determined with <pwdlength> 

<pwdlength>

: integer type maximum length of the password for the facility 

 

This command refers to the GSM/UMTS supplementary service COLP (Connected Line 
Identification Presentation) that enables a calling subscriber to get the connected line identity 
(COL) of the called party after setting up a mobile originated call. The command enables or 
disables the presentation of the COL at the TE. It has no effect on the execution of the 
supplementary service COLR in the network. 
When enabled (and called subscriber allows), +COLP:   

<number>,<type>[,<subaddr>,<satype> [,<alpha>]]

 intermediate result code is returned 

from TA to TE before any +CR or V.25ter [14] responses. It is manufacturer specific if this 
response is used when normal voice call is established. 
Read command gives the status of <n>, and also triggers an interrogation of the provision status 
of the COLP service according 3GPP TS 22.081 [3] (given in <m>).