Amana AGK01 インストール手順

7

In order for condensate water to drain properly inside the unit, the

sleeve must be installed properly:

• Level from right to left.

• A slight downward pitch from the indoor side to the outdoor

side as shown below.

Refer to the Installation Instructions supplied with the PTAC wall

sleeve for a complete description of the installation procedure.

An outside grille must be installed to direct air flow for proper unit

operation and also protect the outdoor coil. The grille must be

installed before installing the chassis. Refer to the Installation

Instructions supplied with the outdoor grille kit for a complete

description of the installation procedure.

This model requires either a Stamped Grille Kit (Model SGK--B),

a Polymer Grille Kit (Model PGK) or an Architectural Grille Kit

(Model AGK--B). When replacing an old chassis with an existing

grille or using a specialized grille in a new installation, please

check with your sales representative to determine if the new

chassis should be used with the non-standard specialized grille.

An improper outdoor grille can decrease cooling or heating

capacity, increase energy usage and shorten compressor life and

possibly void the warranty.

1.

Grasp the cabinet front.

`

2.

Pull the bottom of the cabinet front away from the chassis until
the retaining clips disengage.  NOTE:  If front is secured with
screws, remove front mounting screw, then follow front re-
moval procedure.

Front Mounting

Hole

3.

Lift the cabinet front off the chassis. Reverse this procedure to
reinstall the cabinet front.

1.

Remove the cabinet front from the chassis as described in
Front Removal.

2.

Insert the chassis into the wall sleeve.

3.

Slide the chassis into the wall sleeve until the chassis flanges
contact the front edge of the wall sleeve.