Whirlpool WET4027EW インストール手順

Run water for a few seconds through hoses into a laundry tub, 

drainpipe, or bucket to prevent clogs. Water should run until clear.

Attach hot water hose to the bottom inlet valve. Screw  

coupling by hand until it is snug. Use pliers to tighten  

couplings an additional two-thirds turn. Repeat with cold  

water inlet valve (top valve).

IMPORTANT: To reduce risk of hose failure, replace the hoses 

every 5 years. Record hose installation or replacement dates 

for future reference.

n

   Periodically inspect and replace hoses if bulges, kinks, cuts, 

wear, or leaks are found.

Connect Inlet Hoses

Washer must be connected to water faucets with new inlet 

hoses with flat washers (not provided). Do not use old hoses.
NOTE: Both hoses must be attached and have water flowing 

to inlet valves. If you are only connecting to a cold water  

faucet, you must use a Y-adapter (not included).

Attach hose to hot water faucet. Screw on coupling by hand 

until it is seated on washer. Use pliers to tighten couplings an 

additional two-thirds turn. Repeat this step with second hose 

for cold water faucet.

IMPORTANT: Do not overtighten or use tape or sealants on 

valve when attaching to faucets or washer. Damage can result.

HELPFUL TIP: Make note of which hose is connected to hot 

water to help in attaching hoses to washer correctly. In most 

standard configurations, hoses will cross over each other 

when attached correctly.

Insert a new flat washer into each end of the inlet hoses  

(not provided). Firmly seat the washers in the couplings.

Washer

Coupling

If you are working in a closet or recessed area: move the 

washer/dryer into its final location and remove cardboard 

from under washer/dryer. Remove the outer access panel 

by removing 2 (24" models) or 3 (27" models) Phillips-head 

screws and one bumper (27

" models only), located at the top 

of the access panel. Remove inner access panel (27" models 

only) by removing clip, cover, and 2 screws. Set panels, 

screws, clip, inner access panel cover, and bumper aside. 

Complete hookup of water hoses and vent. Replace access 

panels upon completion of washer/dryer installation.

Outer Access Panel 

(27" model shown)

Inner Access Panel  

(27" models only)