Speed Queen AWNE82SP113TW01 オーナーマニュアル

Rinse & Spin and Spin Cycles

Cycle Stage

Activity

Time (minutes)

Comments

Pre-Wash

Fill/Agitate/Spin

13:10

Option

Rinse

Fill/Agitate/Spin

10:10

Not active in Spin Cycle

Second Rinse

Fill/Agitate/Spin

10:10

Option

Final Spin

Spin

5:00

Optional Features

Bleach Dispenser

The bleach dispenser is located in the left front corner, under the
lid.

Use liquid bleach in the dispenser. Powdered bleach must not be
used in the dispenser. Add powdered bleach to the wash water.

Use no more than one cup chlorine bleach for large loads, three-
quarters cup for medium and one-half cup for small loads.

Carefully pour recommended amount of bleach into the dispenser
during the first fill of the washer.

Be careful not to spill undiluted bleach. It is a strong chemical and
can damage some fabrics if it is not properly diluted.

Fabric Softener Dispenser

Fabric softener is not recommended to be used when the Normal
Eco cycle is selected. For best results, choose an alternate cycle
setting if using fabric softener.

To Use Dispenser

After the clothes are loaded into the washtub and before the
start of the WASH cycle, pour the proper amount of liquid fabric
softener into the bottle measuring cap (refer to bottle directions).
Pour into dispenser.

The large fabric softener dispenser allows for the fabric softener
to be diluted with water. We recommend adding water up to the fill
level. Do not exceed tip of arrow which indicates correct fill level.
Over-filling can allow fabric softener to spill onto the clothes, caus-
ing stains on clothes if the softener comes into contact with de-
tergent suds.

Setting the water level to medium or higher will result in better per-
formance from the fabric softener.

The fabric softener will remain in the dispenser during the wash fill,
agitation and spin. At the end of the wash spin, the liquid fabric
softener will be dispensed into the washtub through the slots in
the agitator and will be mixed with the incoming rinse water.

To Clean the Dispenser

1. Remove the dispenser housing from agitator by squeezing the

lower part of the dispenser, pulling directly upward and at the
same time tilting slightly. This will expose the dispenser cup,
which is also removable for cleaning. Refer to illustration.

2.   Soak both housing and cup in hot soapy water.
3.   Rinse housing and cup clean.
4.   Clean funnel shape in top of agitator by using a small brush.
5.   After cleaning, install dispenser cup, then push dispenser hous-

ing directly downward onto top of agitator until firmly snapped
together.

IMPORTANT: When adding detergent to the wash load,

DO NOT allow any detergent to enter the softener dis-

penser cup. If this happens, refer to the cleaning instruc-

tions.

TLW2001N_SVG

1.   Dispenser Housing
2.   Dispenser Cup
3.   Agitator

Use Tips

• Fabric softener spilled onto garments may cause staining. To

remove, dampen stain and rub with bar soap. Wash as usual.

Cycle Operation

Part No. 203183