Bosch B11CB50SSS 操作ガイド

ページ / 55
en-us
5
Information concerning 
disposal
*
 Disposal of packaging
The packaging protects your appliance from damage 
during transit. All utilized materials are environmentally 
safe and recyclable Please help us by disposing the 
packaging in an environmentally friendly manner.
Please ask your dealer or inquire at your local authority 
about current means of disposal.
*
 Disposal of your old appliance
Old appliances are not worthless rubbish! Valuable raw 
materials can be reclaimed by recycling old appliances.
,
WARNING: 
Redundant appliances
1. Pull out the mains plug.
2. Cut off the power cord and discard with 
the mains plug.
3. Do not take out the trays and receptacles: 
children are therefore prevented from climbing 
in!
4. To prevent children from becoming locked in 
the redundant appliance:
Remove appliance doors!
5. Do not allow children to play with the 
appliance once it has spent its useful life. Risk 
of suffocation!
Refrigerators contain refrigerant and gases in 
the insulation. Refrigerant and gases must be disposed 
of professionally. Ensure that tubing of the refrigerant 
circuit is not damaged prior to proper disposal. 
Scope of delivery
After unpacking all parts, check for any damage 
in transit.
If you have any complaints, please contact the dealer 
from whom you purchased the appliance or our 
customer service.
The delivery consists of the following parts:
Free-standing appliance
Interior fittings (depending on model)
Bag containing installation materials
Operating instructions
Installation instructions
Customer service booklet
Warranty enclosure
Information on the energy consumption and noises
Installing the appliance
Have a technician install and connect the appliance 
according to the enclosed installation instructions.
,
WARNING: 
Do not install this appliance:
outdoors,
in an environment with dripping water,
in rooms where there is a risk of frost.
Transporting
The appliances are heavy and must be secured during 
transportation and installation.
Because of the weight/dimensions of the appliance 
and to minimise the risk of injuries and damage 
to the appliance at least two persons are necessary 
to set-up the appliance securely.
Installation location
A dry, well ventilated room is suitable as an installation 
location. The installation location should not be 
exposed to direct sunlight and not placed near a heat 
source, e.g. a cooker, radiator, etc. If installation next 
to a heat source is unavoidable, use a suitable 
insulating plate or observe the following minimum 
distances from the heat source:
To electric or gas cookers 1
1
/
4
” (3 cm).
To an oil or coal-fired cooker 11
13
/
16
” (30 cm).
The floor of the installation location must not give way; 
if required, reinforce floor. 
Ventilation
The air on the rear panel and on the side panels of 
the appliance heats up. Conduction of the heated air 
must not be obstructed. Otherwise the refrigeration unit 
must work harder. This increases power consumption. 
Therefore: Never cover or block ventilation openings!