Frigidaire FFRE1001PW 仕様シート

ページ / 3
Specifications  
subject to change.
Specifications  
subject to change.
USA
 • 
10200 David Taylor Drive
 • 
Charlotte, NC 28262
 • 
1-800-FRIGIDAIRE
 • 
frigidaire.com 
CANADA
 • 
5855 Terry Fox Way
 • 
Mississauga, ON L5V 3E4
 • 
1-800-265-8352
 • 
frigidaire.ca
FFRE1001P 10/13 
© 2013 Electrolux Home Products, Inc. 
Dryer
FFRE1001PW     
7.0 Cu. Ft. D.O.E.  Electric 
• 
Do NOT install in area exposed to dripping water or outdoor weather 
conditions; where gasoline or other flammables are kept or stored; or 
where dryer comes in contact with curtains, drapes or anything that 
will obstruct flow of combustion and ventilation air.
• 
For garage installation, dryer MUST be located minimum 18" above floor.
• 
Floor MUST be solid with 1" maximum slope. Do NOT install on 
carpeted surface.
• 
Dryer MUST exhaust to outside of building, NOT into any concealed 
space.
• 
Exhaust installation requires minimum 4"-diameter rigid or semi-rigid 
metal duct with approved, unobstructed vent hood having swing-out 
damper(s). If installing rigid metal duct (preferred), do not exceed 
MAXIMUM venting run length of 64 ft., allow deductions for elbows 
and vents. If installing semi-rigid metal duct, do not exceed MAXIMUM 
venting run length of 8 ft., always allow deductions for elbows and 
vents. (Refer to Product Installation Guide on web for additional 
information.) Do NOT use flexible plastic or metal foil duct and use 
shortest run possible.
• 
Leveling legs supplied to level dryer properly and reduce excessive 
noise and vibration.
• 
For manufactured or mobile home installation optional Mobile Home 
Installation Kit (PN # 137067200) required. (For specific installation 
details, refer to Product Installation Guide on web.)
Note:  For planning purposes only. Refer to Product Installation Guide  
on the web at frigidaire.com for detailed instructions.
Optional Accessories
• 
Mobile Home Installation Kit – (PN # 137067200).
• 
Drying Rack – (PN # 137067300).
Top Load Dryer Specifications
• 
Product Shipping Weight (approx.) – 143 Lbs.
• 
Designed for HOME USE only, not recommended for commercial 
application. 
• 
An electrical supply with grounded three-prong receptacle is required.
• 
Voltage Rating – 240V / 60 Hz / 30 Amps
• 
Single phase 3- or 4-wire cable, 240 Volt, 60 Hertz AC only electrical 
supply with ground required on separate circuit fused on both sides 
of line. (Do not use same circuit as washer.)
• 
Connected Load (kW Rating) @ 240 Volts = 5.4 kW
• 
Amps @ 240 Volts = 24 Amps
• 
Dryer MUST employ a 3-conductor NEMA 10-30 type SRDT or 
4-conductor NEMA 14-30 type SRDT or ST (as required), rated at  
240 volt AC minimum, 30 amp power supply cord marked for  
use with clothes dryers (not supplied).
• 
Grounding through neutral link prohibited in specific applications and 
certain locales, requiring use of 4-wire system. (For detailed electrical 
requirements, refer to Product Installation Guide on web.)
• 
Always consult local and national electric codes.
• 
Dryer can be installed in recess or closet requiring 0" minimum 
installation clearance around sides and back of unit. To achieve  
0" minimum rear clearance, dryer MUST be vented straight back. 
Closet installation requires additional 1" minimum clearance between 
front of unit and vented door. Door MUST be vented with 120 sq. in. 
minimum louvered opening, equally divided, located 3" from top and 
bottom of door. A louvered door with equivalent air openings for full-
length of door is acceptable. Air openings MUST remain unobstructed 
with door installed. (For additional installation details, refer to Product 
Installation Guide on web.)
Top Load Laundry - Electric Dryer
Frigidaire Baseline (P Model)
Recess or Closet Installation
Dryer requires 0" minimum installation clearance 
around sides and back of unit. To achieve 0" minimum 
rear clearance, dryer MUST be vented straight back. 
Closet installation requires additional 1" minimum 
clearance between front of unit and vented door. Door 
MUST be vented with 120 sq. in. minimum louvered 
opening, equally divided, located 3" from top and 
bottom of door. A louvered door with equivalent air 
openings for full-length of door is acceptable. 
Air openings MUST remain unobstructed with door 
installed. For additional installation details, refer to 
Product Installation Guide on web.
29"
50"
Side
Reversible 
Door Swing
Vented door
0" min.
1" min.
Side
 60" 
sq. in.
min.
3"
 60" 
sq. in.
min.
3"
0" min.
0" min.
 23"
min.
Front
27"
38 
1
/
2
"
42 
1
/
2
"
Front
13 
1
/
2
"
3
/
4
"
Rear
vent        
240V 
Power 
supply (rear)