Frigidaire FFTR1821QS オーナーマニュアル

ページ / 19
4
INSTALLATION
NOTE
If your refrigerator is placed with the door 
hinge side against a wall, you may have to 
allow additional space so the door can be 
opened wider.
CAUTION
Do Not install the refrigerator where the 
temperature will drop below 55°F (13°C) or 
rise above 110°F (43°C). The compressor 
will not be able to maintain proper 
temperatures inside the refrigerator.
Do Not block the toe grille on the lower front 
of your refrigerator. Sufficient air circulation
is essential for the proper operation of your 
refrigerator.
This Use & Care Guide provides general 
operating instructions for your model. Use the 
refrigerator only as instructed in this Use & 
Care Guide. Before starting the refrigerator, 
follow these important first steps.
Location
•  Choose a place that is near a grounded 
electrical outlet. Do Not use an extension 
cord or an adapter plug.
•  If possible, place the refrigerator out of 
direct sunlight and away from the range, 
dishwasher or other heat sources.
•  The refrigerator must be installed on a floor
that is level and strong enough to support 
a fully loaded refrigerator.
•  Consider water supply availability for 
models equipped with an automatic ice
maker. If you do not hook up water to 
the refrigerator, remember to turn the ice 
maker off.
Installation
Installation clearances
•  Allow the following clearances for ease 
of installation, proper air circulation, and 
plumbing and electrical connections:
Sides & Top
⅜ inch
 Back 
 1 
inch
Guidelines for final positioning of your 
refrigerator:
•  All four corners of the cabinet must rest 
firmly on the floor.
or
 2.  Install left toe grille cover onto slot on 
left side of toe grille.
 3.  Attach toe grille to cabinet.
•  The cabinet should be level at the front 
and rear.
•  The sides should tilt ¼-inch (6 mm) from 
front-to-back (to ensure that doors close 
and seal properly).
•  Doors should align with each other and be 
level.
To install the toe grille:
 1. 
Attach toe grille support bracket to 
cabinet using 3 bolts supplied.