Bosch B30IB800SP インストール手順

,



Avoid the risk of an electric shock!



Insert into a grounded 3-phase socket. 

Never remove grounding phase. Do not use any 

adapters. Do not use any extension cables.



Non-compliance with these instructions may 

result in death, fire or an electric shock. 

Improper connection of the protective 

conductor may result in an electric shock. If you 

are in doubt whether the appliance has been 

grounded properly, have the appliance tested 

by a qualified electrician or service technician. 

The socket must be near the appliance and also freely 

accessible following installation of the appliance. 

The appliance complies with protection class I. 

Connect the appliance to 115 V/60 Hz alternating 

current via a correctly installed socket with protective 

conductor. The socket must be fused with a 10 to 16 A 

fuse. 
The appliance comes with a UL registered 3-wire power 

cord. The appliance requires a 3-pole socket. Please 

observe the following table with regard to this: 

Check on the rating plate whether the indicated voltage 

and current type correspond with the values of your 

power supply. The location of the rating plate can be 

found in the chapter entitled Customer service. 

,

Never connect the appliance to electronic energy 

saver plugs. Our appliances can be used with 

mains and sine-controlled inverters. Mains-

controlled inverters are used for photovoltaic 

systems which are connected directly to the 

national grid. Sine-controlled inverters must be 

used for isolated applications (e.g. on ships or in 

mountain lodges) which are not connected 

directly to the national grid.

,

Only connect the appliance to drinking water!

The water may be connected only by a competent fitter 

according to the local regulations of the appropriate 

water supply company. 
A cold water connection is necessary for operating the 

automatic ice maker. The water pressure must be 

between 25 and 120 p.s.i. (1,72 and 8,25 bar). 

The installation must correspond to the local plumbing 

regulations. 
A separate shut-off valve should be installed in the cold-

water inflow. The shut-off valve should not be located 

behind the appliance. It is recommended that you mount 

the shut-off valve directly next to the appliance or at 

another place which is easily accessible. When installing 

the water connection, pay attention to the permissible 

installation area for the water mains. 
For connection to the drinking water mains use only 

water pipes which are suitable for drinking water. 

Observe national regulations and the connection 

conditions of the local water supply companies. 
When installing the water connection, observe the 

permitted installation areas for the pipe. For the 

permitted installation areas and dimensions see 

“Installation dimensions”.
Maximum outer diameter of the water pipe 

(without fittings):

3

/

8

" (9.5 mm).

BottomFreezer 30" (762 mm)

6.0 Ampere