Frigidaire FGRU19F6QF オーナーマニュアル

5

This Use & Care Guide provides general operating 

instructions for your model. Use the refrigerator 

only as instructed in this Use & Care Guide.  

Before starting the refrigerator, follow these 

important first steps.

Refrigerator

⅜” 

(10 mm)

⅜” 

(10 mm)

•  Choose a place that is near a grounded 

electrical outlet. Do Not use an extension 

cord or an adapter plug.

•  If possible, place the refrigerator out of 

direct sunlight and away from the range, 

dishwasher or other heat sources.

•  The refrigerator must be installed on a floor 

that is level and strong enough to support a 

fully loaded refrigerator.

DO NOT install the refrigerator where the 

temperature will drop below 55°F (13°C) or 

rise above 110°F (43°C). The compressor will 

not be able to maintain proper temperatures 

inside the refrigerator.
DO NOT block the kick plate on the lower 

front of your refrigerator. Sufficient air 

circulation is essential for the proper operation 

of your refrigerator.

Installation clearances:

•  Allow the following clearances for ease 

of installation, proper air circulation, and 

plumbing and electrical connections: 

 

Sides - ⅜” 

 

Top and Back - 1”

•  Allow for trim kit if it is to be installed with  

the unit.



If your refrigerator is placed with the door 

hinge side against a wall, you may have to 

allow additional space so the door can be 

opened wider.

1. Remove handle from carton and any other 

protective packaging. 

2. Position refrigerator handle end caps over 

upper and lower pre-installed shoulder bolts 

(A) that are fastened into door, ensuring 

the holes for the set screws are facing 

towards the outside of door if a single unit 

installation or the freezer door (if installing 

the matching freezer). 

3. While holding handle firmly against door, 

fasten upper and lower Allen set screws (B) 

with supplied Allen wrench. 

4. Repeat steps 2 and 3 to install freezer 

handle (if installing the matching freezer).  

Ensure the holes for the set screws are 

facing towards the refrigerator door.