Dacor DCT365WLPH デザインガイド

www.Dacor.com      Phone: (800) 793-0093  

Specifications subject to change without notice.

Install all appliances according to accompanying installation instructions.

•  To reduce the risk of personal injury caused by reaching over 

a hot appliance, avoid locating cabinet storage space directly 

above the cooktop. 

•  Failure to meet or exceed the maximum and minimum 

dimensions/clearances stated in these instructions may result 

in a fire hazard.

•  Follow the countertop manufacturer’s instructions regarding 

the minimum corner radius, use of heat reflective tape, 

reinforcement of corners, etc.

◊

Carefully check the location where the cooktop will be installed. For 

best performance, the cooktop should be placed away from drafts that 

may be caused by doors, windows and heating and air conditioning 

outlets.

◊

This appliance is to be used in conjunction with a suitable vent hood.

36” (914 mm)

42” (1067 mm)

◊

Allow a minimum ¼” (6 mm) clearance between the bottom of the 

cooktop chassis and all combustible surfaces, including the upper 

edge of a drawer installed below the cooktop.

◊

The gas supply piping, gas shut-off valve and the electrical outlet 

must be located so they do not interfere with the cooktop when it is 

installed. If installing another appliance in the  cabinet below, allow for 

the routing of gas and electrical service behind it.

The installation must allow for the following:
◊

Access to the gas shut-off valve and regulator when the unit is 

installed.

◊

Access to the electrical outlet when the cooktop is in place. The 42” 

(106.7 cm) power cord must be able to reach the electrical outlet

◊

Access to the underside of the cooktop for service and inspection 

purposes

◊

Clearance inside the cabinet to allow for proper hold down bracket 

installation.

To allow access to the utilities and cooktop bottom, a fixed shelf should 

not be installed below the cooktop. See the following pages for countertop 

cutout dimensions.

¼” (6 mm)

mimimum clearance

to combustible

surfaces

 35 ¼” (89.5 cm)*

 * Allows for clearance between hold down brackets

13" max.

3

(33.0 cm)

3

 Not applicable for cabinets more than a horizontal distance of  

  

 

5 ½” (14.0 cm) from edge of cooktop. Allow 6 

7

/

8

” (17.5 cm) 

  

 

from cutout edge.

A

  18" min.

1, 3

(45.7 cm)

 1 

5

/

8

" min. 

(4.1 cm)

Combustible 

surface to rear

Combustible overhead 

cabinets

30" min.

1, 2

(76.2 cm)

See cutout dimensions

See cutout

dimensions

2

 If installing with an overhead vent hood, also check the hood 

  

 

specifications for minimum required clearances.

1

 Measured from the cooking surface (top of cooktop grate).

Cabinet tolerances: +1/16”, -0,  (+1.6 mm, -0) 

unless otherwise stated

Document # PG04-006

Revised 09/29/10   Page 3/4

PRELIMINAR

Y