Whirlpool WED8700EC ユーザーズマニュアル

IMPORTANT: Proper installation of your dryer prior to use is your responsibility. Be sure to read and follow the Installation Instructions

that came with your dryer.

Automatic Setup Instructions – Wi-Fi Protected Setup (WPS)

Press the WPS button on the router. An indicator light will

begin blinking.
HELPFUL TIP: The WPS function on your router is active

for 2 minutes. Complete the next step within that timeframe

or you will need to reinitiate WPS.

Router setup

INTERNET

WI-FI PROTECTED

SETUP (WPS)

HOME WIRELESS

ROUTER

Touch the POWER button (A) to turn on the dryer, then touch

the CONNECT button (B).
The Wi-Fi status indicator (C) on the dryer control panel will

blink slowly while your dryer and router attempt to connect.

The Time/Status display (D) will show a “sensing animation”.

This can take up to 2 minutes.
If the connection is successful, the Wi-Fi status indicator will

come on and remain lit.

If Your Dryer Doesn’t Connect

If your dryer and router fail to connect after 2 minutes,

the Wi-Fi status indicator (C) will blink rapidly for 2 seconds

and then turn off. Refer to the “Troubleshooting — Connectivity”

section of this Use & Care Guide, check any connection

instructions for your specific router, and refer to alternate

instructions at

www.whirlpool.com/connect.

Dryer setup (time sensitive step)

Connectivity Setup

You will need:

• A home wireless router capable of Wi-Fi Protected Setup

(WPS). The router should be on and have a live Internet

connection.

• The Smart Appliance ID (SAID) from your dryer. This is located

on a sticker inside the dryer door.

NOTE: If your home wireless router is not equipped with a WPS

button, please check the user manual of your router to confirm

if it is WPS capable. If not, alternate setup instructions are at

www.whirlpool.com/connect.