MicroFridge 103LMF49TPW オーナーマニュアル

6

1. Locate the microwave oven. Remove the 
   packet of twelve (12) screws located 
   inside the microwave oven. Retain the 
   screws.

2. Place the right bracket flush with the top 
   right side of the refrigerator/freezer with its 
   rear lip facing downward over the back 
   edge of the refrigerator/freezer,the shorter 
   bend without holes should face outward.

3. Align the hole in the rear lip of the bracket 
   with the hole on the back of the 
   refrigerator/freezer, and attach using the 
   screws from Step1.

4. Using the screws from Step 1, attach the 
   bracket(s) to the top of the refrigerator/
   freezer using the three (3) holes located on 
   the bottom of the braket, There are no 
   preset holes in the top of the refrigerator/
   freezer so apply pressure when installing 
   the screws.

5. Place the left bracket flush with the top left 
   side of the refrigerator/freezer with its rear 
   lip facing downward over the back edge of 
   the refrigerator/freezer, the shorter bend
   without holes should face outward.

6. To finish installing the left bracket please repeat steps 4 and 5.

7. Place the microwave oven on top of the refrigerator/freezer and inside the two upright 
   sides of the brackets. Line up the two (2) holes on each side of the microwave oven 
   with those on the brackets, and attach the microwave oven using the screws from 
   Step 1.

8. Plug the refrigerator/freezer AC cord into the outlet on the back of the microwave oven.

9. Plug the AC cord from the microwave oven into an appropriate,grounded outlet.

The MicroFridge

® 

with Safe Plug

® 

combination appliance will now operate with

in 

eleven (11) to fifteen (15) amps of current draw.

NOTE: 
The MicroFridge

® 

with Safe Plug

® 

 brand refrigerator and charging outlets will not operate when 

the microwave oven is on.  This is part of the patent-pending MicroFridge

® 

with Safe Plug

® 

technology 

that prevents wiring overload.

If your oven does not operate properly, unplug it from the 120 volt household outlet and then plug it back in.  
This unit is not designed for 50Hz or any circuit other than 120 volt/60Hz AC current.