KitchenAid KBSD602ESS-SS インストールガイド

Reduce Tipping Radius

(if required)

Before bringing the refrigerator into the home, be sure there is 
adequate ceiling height to stand the refrigerator upright. See 
“Tipping Radius” in the “Installation Requirements” section for 
more information.

If you do not have adequate ceiling height to stand the 
refrigerator upright, the tipping radius can be reduced by 
removing the top grille and side trims (see the following chart). 

1. Grasp both ends of the top grille.

2. Push the top grille straight up; then pull straight out. Lay the 

grille on a soft surface.

3. Remove the six screws attaching each cabinet side trim to 

the refrigerator and remove the side trims.

Move the Refrigerator into House

1. Place an appliance dolly under the left side of the refrigerator 

as shown. Place the corner posts from the packing materials 
over the trims and handles as appropriate to avoid damage. 
Slowly tighten the strap.

NOTE: Pass the dolly strap under the handles for the 
Stainless

 

Series. 

2. Place pieces of the shipping carton on the floor when rolling 

the dolly and refrigerator into the house. Move the refrigerator 
close to the built-in opening.

3. Place top of cardboard carton or plywood under refrigerator. 

4. Stand the refrigerator up. First, place the left bottom edge of 

the refrigerator on the floor, stand the refrigerator upright and 
then lower the right-hand side of the refrigerator to the floor.

5. Reassemble the trim and top grille after the dolly has been 

removed from the refrigerator.

Install Anti-Tip Boards

■

To avoid tipping during use, the solid soffit must be within 
1" (2.5 cm) maximum above the refrigerator. If the solid soffit 
is higher than 1" (2.5 cm) or one is not available, then the 
refrigerator must be braced. 

■

It is recommended that board(s) be installed before the 
refrigerator is installed.

■

Board(s) must be long enough to fully cover the width of the 
compressor cover.

■

Locate the board(s) so the bottom surface(s) of the board(s) 
is(are) 84" (213 cm) from the floor.

■

During installation, raise the refrigerator up so there is 

¹⁄₄" (6.35 mm) maximum between the top of the refrigerator 
and the bottom of the anti-tip board(s). Do not crush the 
compressor cover when raising the rear leveling legs.

NOTE: The foam gasket, on top of the compressor cover, will 
compress to fit under the anti-tip board(s). There is no need 
to trim the gasket.

36

89" (225.9 cm)

42

90¹⁄₂" (229.9 cm)

48

91¹⁄₄" (231.8 cm)

B

B

A