Frigidaire FFES3015LB オーナーマニュアル

SETTING OVEN CONTROLS - MODELS B & C

CAUTION

Use care when opening the oven door after self-clean-

ing cycle. Stand to the side of the oven when opening

the door to allow hot air or steam to escape.

DO NOT force the oven door open. This can damage

the automatic door locking system. Use caution when

opening the door after the self-cleaning cycle is com-

pleted. The oven may still be VERY HOT.

Self-cleaning

To Start the Self-Clean Cycle

*We recommend a 2 hour self-clean cycle for light soils,

and a 3 hour cycle for average to heavy soils (to assure

satisfactory results).

To Set the Controls for a Self-Clean Cycle:

1. Be sure the clock shows the correct time of day.

2. Push

the

CLEAN pad. "- - -" appears in the display.

3. Push

the

UP ARROW pad until "3:00" appears in

the display for a 3 hour cycle, or push the DOWN

ARROW pad until "2:00" appears in the display for a

2 hour cycle.

4. As soon as the UP or DOWN ARROW pad is

released, "CLn" appears in the display.

5. As soon as the controls are set, the motor driven

lock will begin to close automatically and the "Door

Locked" indicator light will fl ash. DO NOT open the

door while the light is fl ashing (it takes about 15

seconds for the lock to close).

6. The "Door Locked" light will glow until the cleaning

cycle is completed or cancelled, and the oven

temperature has cooled.

When the Self-Clean Cycle is Completed:

1. The time of day will appear in the display window

and the "Door Locked" light will continue to glow.

2. Once the oven has cooled down for about 1 hour and

the "Door Locked" light has gone out, the oven door

can be opened.

Stopping or Interrupting a Self-Cleaning Cycle

If it becomes necessary to stop or interrupt a self-

cleaning cycle due to excessive smoke or fi re:

1. Push

the

CLEAR OFF pad.

2. Once the oven has cooled down for about 1 hour and

the "Door Locked" light has gone out, the oven door

can be opened.

3. Correct the condition which caused the smoking.

4. Restart the self-clean cycle once all conditions have

been corrected.

FAILURE MODES

All failure modes give a visual and audible alarm. When

display shows F10 (temperature runaway), F30 (oven

sensor circuit fault) or F90 (motor door lock fault), the

electronic oven control has detected a fault condition.

Note that code and push the CLEAR OFF pad to clean

the display and stop the beeping. Reprogram the oven.

If fault recurs, push CLEAR OFF pad, disconnect the

appliance to prevent damage and contact an authorized

servicer.