KitchenAid KRMF606ESS 使用とお手入れ

1. Select the desired type of ice. To switch between cubed ice 

and crushed ice, press ICE/WATER. 

2. Press a sturdy glass against the dispenser paddle. Hold the 

glass close to the dispenser opening so ice does not fall 
outside of the glass. 
IMPORTANT: You do not need to apply a lot of pressure to the 
paddle to activate the ice dispenser. Pressing hard will not 
make the ice dispense faster or in greater quantities.

3. Remove the glass to stop dispensing. 
NOTE: Ice may continue to dispense for several seconds after 
removing the glass from the dispenser paddle. The dispenser may 
continue to make noise for a few seconds after dispensing.

There is an insert in the dispenser drip tray. The insert can be 
removed from the drip tray to carry to the sink to empty or clean. 

■

Push down on the rear edge of the insert to tilt up the front 
edge for easy removal. 

When you use the dispenser, the light will automatically turn on. 
To turn on the light when you are not dispensing:

Press LIGHT to toggle through the following choices in a 
continuous loop:

■

OFF (default): The dispenser light is off.

■

ON: The dispenser light is on at 100% brightness

■

DIM: The dispenser light is on at 50% brightness

The dispenser lights are LEDs that cannot be changed. If it 
appears that your dispenser lights are not working, see 
“Troubleshooting” for more information. 

The Dispenser Lock 

The dispenser can be disabled for easy cleaning or to avoid 
unintentional dispensing by small children and pets. 
NOTE: The lock feature does not shut off power to the refrigerator, 
to the ice maker, or to the dispenser light. It simply deactivates the 
controls and dispenser levers. To turn off the ice maker, see “Ice 
Maker and Storage Bin.”

■

Press and hold LOCK for 3 seconds to lock the dispenser. 

■

Press and hold LOCK for 3 seconds to unlock the dispenser.

The display screen indicates when the dispenser is locked. 

Ice Maker and Ice Storage Bin 

(on some models)

IMPORTANT: To avoid low ice production and poor quality ice, 
flush the water system before turning on the ice maker. See 
“Water Dispenser.”

■

Following installation, allow 24 hours to produce the first 
batch of ice. Discard the first three batches of ice produced. 
Allow 2 to 3 days to fill the ice storage bin. 

■

The quality of your ice will be only as good as the quality of the 
water supplied to your ice maker. Avoid connecting the ice 
maker to a softened water supply. Water softener chemicals 
(such as salt) can damage parts of the ice maker and lead to 
poor quality ice. If a softened water supply cannot be avoided, 
make sure the water softener is operating properly and is well 
maintained.

■

If the ice in the storage bin clumps together, break up ice 
using a plastic utensil and discard. Do not use anything sharp 
to break up the ice. This can cause damage to the ice bin and 
the dispenser mechanism.

■

Do not store anything in the ice storage bin.

The ice maker is located on the left-hand side of the refrigerator 
compartment ceiling. Ice cubes are ejected into the ice storage 
bin, located on the left-hand refrigerator door.

 

1. Push up on the latch on the left-hand side of the ice 

compartment to open the door. 

A