Philips AZ105S/05 クイック設定ガイド
For online help
Turn off
Warning and maintenance
To get the detailed instructions for use, visit
www.philips.com/support.
OFF
User Manual
AZ105
www.philips.com/welcome
Always there to help you
Register your product and get support at
Question?
Contact
Philips
1 Important
•
Read these instructions.
•
Follow all instructions.
•
Do not block any ventilation openings. Install in accordance with the manufacturer’s
instructions.
instructions.
•
Do not install near any heat sources such as radiators, heat registers, stoves, or other
apparatus (including amplifi ers) that produce heat.
apparatus (including amplifi ers) that produce heat.
•
Protect the power cord from being walked on or pinched, particularly at plugs,
convenience receptacles, and the point where they exit from the unit.
convenience receptacles, and the point where they exit from the unit.
•
Only use attachments/accessories specifi ed by the manufacturer.
•
Unplug this unit during lightning storms or when unused for long periods of time.
•
Refer all servicing to qualifi ed service personnel. Servicing is required when the unit
has been damaged in any way, such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the unit has been exposed to rain
or moisture, does not operate normally, or has been dropped.
has been damaged in any way, such as power-supply cord or plug is damaged, liquid has
been spilled or objects have fallen into the apparatus, the unit has been exposed to rain
or moisture, does not operate normally, or has been dropped.
•
Battery usage CAUTION – To prevent battery leakage which may result in bodily injury,
property damage, or damage to the unit:
•
property damage, or damage to the unit:
•
Install all batteries correctly, + and - as marked on the unit.
•
Do not mix batteries (old and new or carbon and alkaline, etc.).
•
Remove batteries when the unit is not used for a long time.
•
Batteries (battery pack or batteries installed) shall not be exposed to excessive heat
such as sunshine, fi re or the like.
such as sunshine, fi re or the like.
•
The unit shall not be exposed to dripping or splashing.
•
Do not place any sources of danger on the unit (e.g. liquid fi lled objects, lighted
candles).
candles).
•
Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
disconnect device shall remain readily operable.
Warning
•
Never remove the casing of this apparatus.
•
Never place this apparatus on other electrical equipment.
•
Never look into the laser beam inside this apparatus.
Caution
•
Use of controls or adjustments or performance of procedures other than herein may result in hazardous
radiation exposure or other unsafe operation.
radiation exposure or other unsafe operation.
Mains fuse
This information applies only to products with a UK mains plug.
This product is fi tted with an approved molded plug. If you replace the fuse, use one with:
•
This product is fi tted with an approved molded plug. If you replace the fuse, use one with:
•
the ratings shown on the plug,
•
a BS 1362 approval, and
•
the ASTA approval mark.
Contact your dealer if you are not sure about what type of fuse to use.
Caution: To conform with the EMC directive (2004/108/EC), do not detach the plug from the
power cord.
Caution: To conform with the EMC directive (2004/108/EC), do not detach the plug from the
power cord.
2 Notice
This product complies with the radio interference requirements of the European Community.
Any changes or modifi cations made to this device that are not expressly approved by Philips
Consumer Lifestyle may void the user’s authority to operate the equipment.
Any changes or modifi cations made to this device that are not expressly approved by Philips
Consumer Lifestyle may void the user’s authority to operate the equipment.
Your product is designed and manufactured with high quality materials and components, which can
be recycled and reused.
be recycled and reused.
When this crossed-out wheeled bin symbol is attached to a product it means that the product is
covered by the European Directive 2002/96/EC.
Please inform yourself about the local separate collection system for electrical and electronic
products.
Please act according to your local rules and do not dispose of your old products with your
normal household waste. Correct disposal of your old product helps to prevent potential negative
consequences for the environment and human health.
covered by the European Directive 2002/96/EC.
Please inform yourself about the local separate collection system for electrical and electronic
products.
Please act according to your local rules and do not dispose of your old products with your
normal household waste. Correct disposal of your old product helps to prevent potential negative
consequences for the environment and human health.
No sound
•
Adjust the volume.
No response from the unit
•
Take out the batteries and turn on the unit again.
•
Disconnect and reconnect the AC power plug, then turn on the unit again.
No disc detected
•
Insert a disc.
•
Check if the disc is inserted upside down.
•
Wait until the moisture condensation at the lens has cleared.
•
Replace or clean the disc.
•
Use a fi nalized CD or correct format disc.
Poor radio reception
•
Increase the distance between the unit and your TV or VCR.
•
Fully extend the FM antenna.
Your product contains batteries covered by the European Directive 2006/66/EC, which cannot be
disposed with normal household waste. Please inform yourself about the local rules on separate
collection of batteries because correct disposal helps to prevent negative consequences for the
environmental and human health.
disposed with normal household waste. Please inform yourself about the local rules on separate
collection of batteries because correct disposal helps to prevent negative consequences for the
environmental and human health.
Environmental information
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate
into three materials: cardboard (box), paper pulp (buffer) and polyethylene (bags, protective foam
sheet.)
Your system consists of materials which can be recycled and reused if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packaging materials,
exhausted batteries and old equipment.
All unnecessary packaging has been omitted. We have tried to make the packaging easy to separate
into three materials: cardboard (box), paper pulp (buffer) and polyethylene (bags, protective foam
sheet.)
Your system consists of materials which can be recycled and reused if disassembled by a specialized
company. Please observe the local regulations regarding the disposal of packaging materials,
exhausted batteries and old equipment.
This apparatus includes these labels:
Class II equipment symbol
This symbol indicates that the apparatus has a double insulation system.
Note
•
The type plate is located at the bottom of the apparatus.
3 Product
information
Note
•
Product information is subject to change without prior notice.
Specifi cations
Rated Output Power
2 x 1 W RMS
Frequency Response
63 -14000 Hz, -3 dB
Signal to Noise Ratio
>57 dBA
Total Harmonic Distortion
<1 %
Audio-in Input
650 mV RMS
Tuning Range
FM: 87.5 - 108MHz
Speaker Impedance
8 ohm
Power supply
- AC Power
- Battery
- AC Power
- Battery
220 - 240V, 50/60 Hz
9 V, 6 x 1.5 V R14/UM2
Operation Power Consumption
15 W
Standby Power Consumption
< 0.5 W
Dimensions - Main Unit (W x H x D)
261 x 123 x 245 mm
Weight - Main Unit
1.1 kg
4 Troubleshooting
Warning
•
Never remove the casing of this device.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this device, check the following points before requesting
service. If the problem remains unsolved, go to the Philips Web page (www.philips.com/support).
When you contact Philips, make sure that the device is nearby and the model number and serial
number are available.
If you encounter problems when using this device, check the following points before requesting
service. If the problem remains unsolved, go to the Philips Web page (www.philips.com/support).
When you contact Philips, make sure that the device is nearby and the model number and serial
number are available.
No power
•
Ensure that the AC power plug of the unit is connected properly.
•
Ensure that there is power at the AC outlet.
•
Insert the batteries with their polarities (+/– signs) aligned as indicated.
•
Replace the battery.
AZ105_05_QSG_V1.0.indd 2
AZ105_05_QSG_V1.0.indd 2
9/14/2012 10:43:42 AM
9/14/2012 10:43:42 AM